V1 ENGLISH 14-1229
7(Optional)To improve speaker
performance, insert unbacked berglass
insulation behind and around the speaker.
Warning:To avoid personal injury, wear
gloves when inserting the insulation.
8Pull the wires through the hole in the
ceiling. Strip o the end of the outer wire
jacket, then strip about ½ inch of the
insulation from the ends of the wires.
9Connect the positive wire on your audio
equipment to the red terminal on the
speaker, then connect the negative wire
on your audio equipment to the black
terminal on the speaker.
Warning: Make sure that your audio
equipment is turned o before you connect
the speaker wires.
10 Remove the speaker grill by pushing one
of the mounting clip screws towards the
front of the speaker, then insert the
speaker into the hole in the ceiling.
11 Using the pre-installed screws on the
speaker, screw the speaker into the
ceiling. Tighten the screws evenly until
the speaker is at against the ceiling.
Caution: If you use a drill to tighten the
screws, make sure that you set the drill to its
lowest torque setting. Do not overtighten
screws.
12 Reinstall the speaker grill by pushing it
onto the speaker.
Painting the speakers and grills
The speakers have an ABS nish that you can paint.
To paint the speakers and grills:
1Remove the grills from the speakers.
2Make sure that the interior of the speaker is covered so no paint will get
inside.
3Insert one of the supplied paint plugs into the speaker to protect the
speaker.
4Carefully paint the exposed part of the speaker. Remove the plug when
you have nished painting.
5Spray the grill with thin paint (5 parts thinning agent to 1 part paint).
Make sure that you do not plug the holes on the grill with paint.Too
much paint may adversely aect the speaker sound.
Specifications
• 6 1/2" Polypropylene woofer
• 1/2" pivoting Mylar tweeter
One-year warranty
Dynex Products (“Dynex”) warrants to you, the original purchaser of this new Product, that the
Product shall be free of defects in the original manufacture of the material or workmanship for
a period of 1 year from the date of your purchase of the Product (“Warranty Period”).This
Product must be purchased from an authorized dealer of Dynex brand products and packaged
with this warranty statement.This warranty does not cover refurbished Product. If you notify
Dynex during the Warranty Period of a defect covered by this warranty that requires service,
terms of this warranty apply.
How long does the coverage last?
TheWarranty Period lasts for 1 year from the date you purchased the Product.The purchase
date is printed on the receipt you received with the Product.
What does this warranty cover?
During the Warranty Period, if the original manufacture of the material or workmanship of the
Product is determined to be defective by an authorized Dynex repair center or store personnel,
Dynex will (at its sole option): (1) repair the Product with new or rebuilt parts; or (2) replace
the Product at no charge with new or rebuilt comparable products or parts. Products and parts
replaced under this warranty become the property of Dynex and are not returned to you. If
service of Products or parts are required after theWarranty Period expires, you must pay all
labor and parts charges.This warranty lasts as long as you own your Dynex Product during the
Warranty Period.Warranty coverage terminates if you sell or otherwise transfer the Product.
How to obtain warranty service?
If you purchased the Product at a retail store location, take your original receipt and the Product
to the store you purchased it from. Make sure that you place the Product in its original packaging
or packaging that provides the same amount of protection as the original packaging. If you
purchased the Product from an online web site, mail your original receipt and the Product to the
address listed on the web site. Make sure that you put the Product in its original packaging or
packaging that provides the same amount of protection as the original packaging.
www.dynexproducts.com
Where is the warranty valid?
This warranty is valid only to the original purchaser of the product in the United States,
Canada, and Mexico.
What does the warranty not cover?
This warranty does not cover:
• Customer instruction
• Installation
• Set up adjustments
• Cosmetic damage
• Damage due to acts of God, such as lightning strikes
• Accident
• Misuse
• Abuse
• Negligence
• Commercial use
• Modication of any part of the Product, including the antenna
• Plasma display panel damaged by static (non-moving) images applied for lengthy periods
(burn-in).
This warranty also does not cover:
• Damage due to incorrect operation or maintenance
• Connection to an incorrect voltage supply
• Attempted repair by anyone other than a facility authorized by Dynex to service the Product
• Products sold as is or with all faults
• Consumables, such as fuses or batteries
• Products where the factory applied serial number has been altered or removed
Contact Dynex:
For customer service, call 1-800-305-2204 (U.S. and Canada) or
01-800-926-3020 (Mexico)
www.dynexproducts.com
DYNEX is a trademark of Best Buy and its aliated companies.
Registered in some countries.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2014 Best Buy. All rights reserved.
Made in China
