E-Core DuroRack 6 User manual

Assembly Instructions for Ecore DuroRacks
Fixed Wall Mount Cabinets 6, 9, and 15RU
BOX INCLUDES:
(1pc) Locking Plexiglass Front Panel
(1 pc) Front Frame
(2 pcs) Side Frame
(2 pcs) Locking Side Panel
(1 pc) Top Panel including Fan
(1 pc) Back Panel
(4 pcs) Cage-Nut Style Rack Rail
(1 pc) Bottom Panel
Assembly Hardware (Cage Nuts, Rack Screws, Washers and Keys)
TOOLS Required:
Phillips Head Screwdriver
STEP 1
Remove the Locking Side Panels from the Side
Frames and set aside.
STEP 2
Remove Locking Plexiglass Front Panel and plastic
spacer washer from the Front Frame and set aside.
STEP 3
Prepare Rack Screws for installation by inserting the
Washers on to the Rack Screws.
STEP 4
Install (4) Cage Nuts in the corner holes of the Side
Frame. Then install (2) Cage Nuts onto the front
facing ports of the Side Frame. Repeat for second
Side Frame.
Make sure to use the appropriate mounting
hardware for your application. Due to the various
types of walls that the cabinet may be installed on,
mounting hardware is not included. Mount the Back
Panel to the wall and proceed to Step 1.
STEP 5
Align the Rack Rails to the side panel so that the
screw holes match up to the Cage Nuts. Tighten
the Rack Screws into the Cage Nuts. Repeat for the
second Side Frame and two remaining Rack Rails.

STEP 7 STEP 8
Line up the Side Frame with the Cage Nuts on the
Back Panel and install Rack Screws securing the Side
Frame in place. Repeat this step for the other Side
Frame.
Install the Top Panel by sliding the rear tab
underneath the lip of the Back Panel and resting on
top of the Side Panels.
Install the Bottom Panel by sliding the rear tab over
the lip of the Back Panel and have someone assist
by holding the Bottom Panel in place while
completing Step 10.
STEP 9 STEP 10 STEP 11
STEP 12
Install the Front Panel by ensuring that it ts over
the tab of the Top Panel and under the tab of the
Bottom Panel, snapping into place securely. Tighten
Rack Screws in to the front facing Cage Nuts
installed on each Side Frame in Step 4.
Re-attach the Locking Plexiglass Front Panel. Make
sure to slide the plastic spacer back on and squeeze
the hinge lock to get it into position. Finish by locking
the door.
Slide the Locking Side Panels in to place and nish
by locking them.
Congratulations, you have successfully installed
the Ecore DuroRacks Fixed Wall Mount Cabinet.
STEP 6
Install (2) Cage Nuts on each side of the Back
Panel.