Eco-Systems ECO-29C User manual

866.463.2611 •www.ecosystemsdisplays.com
Setups
Order ##### - ECO-29C Sustainable Display Stand
1
2
3
Shelf
Wing
3
2A
When assembled
Item
1
2/2A
3
Qty.
1
1/1
2
Description
Base Plate
33” Q914 Vertical Extrusion
14” Z32 Waterfall Bracket
Steps:
1) Assemble verticals [2] & [2A]. See Q914 Connector detail.
2) Install Base Plate to vertical [2/2A].
3) Connect A10 Clamps to left and right sides of vertical [2/2A];
insert wings. See A10 Clamp detail.
4) Install Waterfall Brackets [3] to front and back of vertical [2/2A].
5) Attach Laptop Shelf to front of vertical [2/2A]. See Shelf Attachment detail.
6) Affix Header Graphics to front and back using Velcro, as shown.
2) Tighten set screw to
secure A10 to extrusion.
1) Slide A10 connector
into groove of extrusion.
A10 Clamp
Wing
4) Tighten knob to secure
wing in place.
3) Insert wings into clamp.
1
2
3
4
Screws
Connector
Q914 Connector
Slide extrusion over
connector and rest on
lower vertical.
Secure with screws.
Note: To prevent product
loss, Keep all screws
attached to connector
piece after disassembling.
**
*
Shelf Attachment
Insert lock into groove
of vertical extrusion and
tighten setscrew.
*
Lock Setscrew
Back of Shelf
Setscrew will face
outward for ease
of assembly
Header
Graphic

866.463.2611 •www.ecosystemsdisplays.com
General Info
7A
General Setup Instructions
•The setup instructions are created specifically for your configuration.
•Setup instructions are laid out sequentially in levels, including exploded
views and a logical series of steps for assembly. We encourage you to study
the instructions before attempting to assemble your exhibit.
Hex Tool for Assembling Exhibit Extrusion Lock Connectors
Numbering Instructions for Setups/Packing Inline Connection between Extrusions Baseplate Connection for Vertical Extrusions
Cleaning and Packing
•Use non-abrasive cleaners when cleaning extrusions or ECO Glass inserts.
•Use mild cleaners and soft materials such as cotton to clean all laminates.
•Keep exhibit components away form extreme heat and long exposure to
sun light. This will prevent warping and fading.
•Retain all packing material for ease of re-packing. This protects the exhibit
components and keeps each part organized.
Disassembling
•When disassembling exhibit, tighten all setscrews to prevent loss of hardware
in the shipping process.

866.463.2611 •www.ecosystemsdisplays.com
Case 1
2
3
3
Wings
(qty 4)
Header Graphic
1
(base plate)
Shelf
2A
Setup Hardware
Top View of Each Level
Level 1 Level 2 Level 3