Step 1
Before starting lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts necessary
for the primary mount you are attaching to before attempting to
assemble the mount. Note: VH-001 part numbers are in circles and
non-VH-001 part numbers are in hexagons.
Step 2
To determine which steps to follow, first determine which mount you
are trying to attach to the VH-001. If you are trying to connect the
VH-001 to a W-13 or a C-13 proceed to step 3. If you are trying to
connect the VH-001 to a C-20, C-27, W-20, or W-27 proceed to step
6. IfyouaretryingtoconnecttheVH-001toanewstyleVMP014/024,
VMP036/038, VMP042/044, or VMP046/048 proceed to step 9. If you
are trying to connect the VH-001 to a VMP001, VMP003, or VMP006
proceed to step 11. Note: Instructions assume that you have al-
ready assembled the primary mount.
VH-001 to W13 or C13
Step 3
First remove the TV from the mount. Next remove the platform )
W-13 or C-13 by removing the nylon nut and washer and )
W-13 or and C-13.
Step 4
Remove the plastic swivel W-13 and C-13. Snap off the plastic
circle on the bottom of the plastic swivel W-13 and C-13 and
remove the 2.5” long screw W-13 or C-13.
Step 5
Attach the VH-001 force arm VH-001 to the bottom of the plastic
swivel by inserting the long screw VH-001 through the platform
W-13 or C-13 through the plastic swivel VH-001 and the
spacer VH-001. Continue by inserting the long screw through
the VH-001 force arm VH-001 and through the plug VH-001,
washer VH-001, and then attach and tighten the nylon nut )
VH-001. Once this is completed please skip to step 14.
Step 3: Removing the platform from
the W-13/C-13
Step 4: Removing the plastic
connector and swivel
Step 5: Attaching the force arm
Key:
VIDEO MOUNT PRODUCTS
VH-001
Non VH-001
Parts
7
1
7
1
4
5
1
4
1
8
10
7
10
71
4
10
13
11
112
13 14
