EHX DELUXE MEMORY MAN User manual

FCC COMPLIANCE
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the CC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment under CC rules.
DELUXE MEMORY MAN
ANALOG DELAY WITH CHORUS/VIBRATO
Congrat lations on yo r p rchase of the Del xe Memory Man with
Chor s/Vibrato. The Del xe Memory Man is designed with state-of-the-art
solid state circ itry to give yo years of high q ality, tro ble free
performance. The EH XO version of the Del xe Memory Man is an exact
reiss e of the original Del xe Memory Man with one pgrade: tr e bypass.
-POWER -
- OPERATING INSTRUCTIONS and CONTROLS -
Connect your guitar to the INPUT jack, and the OUTPUT jack into the input of your
amp. Your Memory Man can be used in combination with other effects devices —
experiment to develop your own unique sound. The bypass footswitch on top of the
unit allows you to switch the effect in and out. Unmodified signal is always available
at the DIRECT OUT jack. Set the LEVEL control so that the OVERLOAD LED blinks
on with the loudest notes you play, but does not come on very brightly or too
frequently. Overdriving the unit will cause distortion.
The BLEND control allows you to vary the mix of direct and delayed signals; it is set
to the center position equal levels of both.
The FEEDBACK provides delay repeats, or multiple echoes. If set very high, runaway
oscillation will occur. airly high feedback with short delay settings produces a reverb
effect.
The DELAY control determines the time between direct and delayed signals, and
between the repeats when feedback is used. Strange, eerie and unusual pitch-shift
Warning: Your unit comes equipped with a 24 Volt/100mA AC external
power adapter. Use only the power adapter s pplied, and make sure it
is appropriate to your location (USA, Europe, Japan, Australia). Use of the
wrong adapter can cause damage to the unit or to you, and will void the
warranty. Connect the included 24DC/100mA AC Adapter to the Power Jack,
located at the top center of the Deluxe Memory Man.

effects can be produced by changing the delay while playing, especially while using
feedback.
The CHORUS/VIBRATO switch allows you to choose between Chorus or Vibrato
mode. The DEPTH control sets the amount of modulation in the delay time. The
modulation rate is slow for chorus and faster for vibrato. The Vibrato mode produces
a “Doppler” pitch shifting effect in the delayed signal. A rich, vibrant chorus effect is
produced with the switch set to CHORUS, delay fairly short, blend at the center,
chorus set high, and feedback fairly high. When you determine the control settings
for your favorite effects, make note of them so you can quickly set up the unit before
playing.
The FOOTSWITCH engages/disengages the effect. If the effect is engaged, the
status LED above the footswitch will light up. In true-bypass mode, the status LED is
off.
Unpl g after se. Avoid operating near moist re. Rock-n-Roll!
- WARRANTY INFORMATION -
Please register online at http://www.ehx.com/product-registration or complete and
return the enclosed warranty card within 10 days of purchase. Electro-Harmonix will
repair or replace, at its discretion, a product that fails to operate due to defects in
materials or workmanship for a period of one year from date of purchase. This
applies only to original purchasers who have bought their product from an authorized
Electro-Harmonix retailer. Repaired or replaced units will then be warranted for the
unexpired portion of the original warranty term.
If you should need to return your unit for service within the warranty period, please
contact the appropriate office listed below. Customers outside the regions listed
below, please contact EHX Customer Service for information on warranty repairs at
[email protected] or [phone]. USA and Canadian customers: please obtain a
Ret rn A thorization N mber (RA#) from EHX Customer Service before returning
your product. Include with your returned unit: a written description of the problem
as well as your name, address, telephone number, e-mail address, and RA#; and a
copy of your receipt clearly showing the purchase date.
United States & Canada
EHX CUSTOMER SERVICE
ELECTRO-HARMONIX
c/o NEW SENSOR CORP.
55-01 2ND STREET
LONG ISLAND CITY, NY 11101
Tel: [phone]
Email: [email protected]
E rope
JOHN WILLIAMS
ELECTRO-HARMONIX UK
13 CWMDONKIN TERRACE
SWANSEA SA2 0RQ
UNITED KINGDOM
Tel: [phone]
Email: [e-mail]
This warranty gives a purchaser specific legal rights. A purchaser may have even
greater rights depending upon the laws of the jurisdiction within which the product
was purchased.
To hear demos on all EHX pedals visit us on the web at www.ehx.com
Email us at [email protected]