Delay start button
You can delay the start of the programme for
between 1 and 19 hours.
Refer to 'Select and start a washing pro-
gramme' chapter for the set of this function.
Function buttons (A, B and C)
The following functions can be set using
these buttons:
• adjustment of the water softener level,
• activation/deactivation of the rinse aid dis-
penser when multitab function is active.
Setting mode
The appliance must be in setting mode
when you:
– select a washing programme,
– adjust the water softener level,
– activate/deactivate the rinse aid dis-
penser.
Switch on the appliance.
– All programme indicator lights come on,
the appliance is in setting mode.
Switch on the appliance.
– Only one programme indicator light comes
on, the last selected programme is still set.
In this case, to go back to the setting
mode, you must cancel the programme.
– Simultaneously press and hold the cancel
button until all the programme indicator
lights come on. The programme has been
cancelled and the appliance is now in set-
ting mode.
First use
Before using your dishwasher for the first
time:
• Ensure that the electrical and water con-
nections comply with the installation in-
structions
• Remove all packaging from inside the ap-
pliance
• Set the water softener level
• Pour 1 litre of water into the salt container
and then fill with dishwasher salt
• Fill the rinse aid dispenser
If you want to use combi detergent
tablets such as: '3 in 1', '4 in 1', '5 in
1' etc. set the multitab function. (Re-
fer to 'Multitab function').
Setting the water softener
The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
The higher the content of these minerals and
salts, the harder your water is. Water hard-
ness is measured in equivalent scales, Ger-
man degrees (dH°), French degrees (°TH)
and mmol/l (millimol per litre - international
unit for the hardness of water).
The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.
The water softener must be set in two
ways: manually, using the water hard-
ness dial and electronically.
Water hardness Adjusting the water hardness setting Use of
salt
°dH °TH mmol/l manually electronically
51 - 70 91 - 125 9,1 - 12,5 2level 10 yes
43 - 50 76 - 90 7,6 - 9,0 2level 9 yes
37 - 42 65 - 75 6,5 - 7,5 2level 8 yes
29 - 36 51 - 64 5,1 - 6,4 2level 7 yes
23 - 28 40 - 50 4,0 - 5,0 2level 6 yes
19 - 22 33 - 39 3,3 - 3,9 2level 5 yes
15 - 18 26 - 32 2,6 - 3,2 1level 4 yes
electrolux 5