Elitech EL-026 User manual

WASHER
8* 13(×3)
2
SPRING WASHER
5/16"(×3)
3
WASHER
12.5* 25*
T=3(×3)
1
NYLON NUT
5/16"(×3)
4
BRAKE SCREW
M6*P1.0
*L6mm(×2)
5
WRENCH
NO.13(×1)
8
ALLEN WRENCH
NO.3(×1)
6
ALLEN WRENCH
NO.4(×1)
7
76
LCD MOUNT
76mm(×2)
C
82
LCD MOUNT
82mm(×1)
D
JOINT(×1)
B
TUBE
L400(×1)
E
CABLE CLIP(×1)
G
SCREW
M4*P0.7*
L12mm(×12)
9
FOR LCD monitor
F
BASE(×1)
A
FOLD ARM(×1)
C
or
D
9
To install LCD Mount(C) in the back of monitor:
Locate mounting screw fixtures on the back
of monitor and attached LCD mount(C OR D)
with screw(9).
Make sure the screw(9) match to your monitor
hole to fix the LCD Mount(C OR D).
Component list EL-026

A
G
To route your cable from the cable case
which inside of the Fold arm(A) and
cable clip(G) for a tidy look.
STEP 4
STEP 3
CC
D
A
2
3
4
B
1
Installing LCD Mount(C) to Fold arm(A)
and LCD Mount(D) to Joint(B).
E
G
F
STEP 1
Installing Tube(E) on the base(F) and
then put on the Cable clip(G) on the
tube for cable management.
Fixed the brake screw(3) with Allen
wrench(6) to avoid rotation of the tube.
STEP 2
A
B
E
Put the Fold arm(A) and Joint(B) through
the Tube(E).
To adjust the height of Fold arm(A) and
Joint(B) with Allen wrench(7).
6
3
4
7
8
Assembly steps
Answer: Please follow steps below to set the tilting angle
Use a flat-blade screwdriver
to push open the caps.
2.
1.
Locate the two caps which
are on each side of the axis
of the monitor bracket.
3. Loosen the nut adjust
the tilting angle then
tighten the nutadain.
loose
tighten
WRENCH NO.13
30
90
2. 1.
SCREWDRIVER
Why my monitors keep flopping?