Emerson CR440BE User manual

CR440BE
Visit our Web site at "www.emersonradio.com"
UNAUTHORIZED MODIFICATIONS TO THIS DEVICE COULD VOID MANUFACTURER'S WARRANTY

THIS PAGE INTENTIONALLY LEFT BLANK

1. The Handle
2. Refrigerator Door
3. Leveling Feet

1.
2.
3. DripTray
4. Shelf
5.
6. Crisper Drawer Cover
7. Crisper Drawer
8.
9.
10.
Thermostat Control Knob
Chiller Compartment
Refrigerator Compartment
Bottle Storage
Soda Can Storage
Door Gasket

5
NOTES: Temperature range of the chiller compartment is 30°F to 48°F at room temperature of 77°F
(25°C). Ice cream and Popsicles must be kept cool at -5°F to 0°F, hence this chiller compartment is not
suitable to store these types of items.
USING THE THERMOSTAT
DEFROSTING
The thermostat control for the refrigerator and
chiller is located at the upper right hand
orner of the chiller compartment.
The first time you turn the unit on, adjust the
thermostat control knob to 3 and give your
refrigerator time to cool down completely
efore adding food; a full 24 hours is
ecommended.
After it is fully cooled, test it and adjust
owards 1 to make less cool or towards 6 to
ool more to best suit your needs. However,
he setting of 3 should be appropriate for
ome or office refrigerator use.
Turning the control knob to
he OFF position will stop the cooling cycle.
thermostat
NOTE:
c
r
b
t
c
t
h
t
If the chiller has
accumulated excessive frost/ice please do the
following:
1. Turn the thermostat knob to the OFF
osition and leave the chiller door open.
2. Remove all food and ice cube tray or
ransfer to refrigerator compartment.
3. Place towel under compact refrigerator or
ove refrigerator outdoors where no water
amage can occur.
4. Clean and wipe out the melted frost with a
loth.
To avoid damaging the chiller
ompartment wall, do not use any sharp
bjects to remove the frost or to separate the
rozen food.
Chiller compartment:
NOTE:
p
t
m
d
c
c
o
f

1
.
2
To avoid to yourself and/or property, we recommend someone assist you during the door
reversal process.
injury
NOTE:
To take the door off it is necessary to tilt the
Appliance backward. You should rest the
Appliance on something solid, e.g. a chair just
below the top panel.
DO NOT lay the Appliance completely flat as
this may damage the coolant system.
•Ensure the Appliance is unplugged and empty.
•Adjust the two leveling feet to their highest
position.
•We recommend you have someone to assist
you.
•8mm socket screw driver
•Phillips style screw driver
1. Upper Hinge Bracket
2. Adjustable Leveling Foot
3. Machine Screw
4. Bottom Hinge Bracket
5. Level Foot
Remove the upper hinge cover, then unscrew the upper screws of metal hinge bracket and take off
the hinge. Then take off the left side screw cover. Pull the appliance door upward to take it off.
At the same time, remove the mounting screws next to left leveling foot .
Remove left leveling foot andthe bottom hinge bracket by unscrewing the mounting screws.
REVERSING THE DOOR POSITION

0.8A
226 kwh

CR440BE-20140526-01