Enable healthcare iHealth User manual

Getting Started
01. Remove the smartphone and charger from
box. The phone is suciently charged for the
rst use. Take out Glucometer (batteries are
already placed in).
02. Start your phone, power ON button is on the
right side. Hold button until logo appears. Be
sure the phone is turned on before you take a
reading. (see diagram 01)
03. The smartphone and glucometer have
already been connected for you. The phone
needs to remain on for continued connection.
This is not an emergency response unit. If you are experiencing any unusual
symptoms, please seek medical help immediately, or dial 911.
remote patient monitoring
by enable healthcare
05. Insert the test strip into the meters strip
port with the contact bars facing toward you
and the white arrow facing up.
(see diagram 03)
04. Power on glucometer by pushing the
button on the right side of meter. The meter
will light up. (see diagram 02)
diagram 01
Always keep smartphone plugged into charger.
Power button
diagram 02 diagram 03
Strip port

06. Prepare the lancing device. (see diagram 04).
remote patient monitoring
by enable healthcare
Getting Started (cont’d)
diagram 04
Always keep smartphone plugged into charger.
This is not an emergency response unit. If you are experiencing any unusual
symptoms, please seek medical help immediately, or dial 911.
Snap o the lancet device cap. Insert a new lancet rmly into
the lancing holder cup.
Twist the lancet cover o.
Replace the lancing device cap. Set the lancing level.
Cock the handle until it clicks.
07. Please clean your index nger with an alcohol swab before obtaining your blood sample.

08. Obtain your blood sample by pressing the lancing device against your index nger.
Press the release button to puncture the site and gently squeeze your nger until a drop
of blood forms. (see diagram 05).
remote patient monitoring
by enable healthcare
Getting Started (cont’d)
Always keep smartphone plugged into charger.
This is not an emergency response unit. If you are experiencing any unusual
symptoms, please seek medical help immediately, or dial 911.
09. Apply your blood sample to the test strip by holding the edge of the test strip to your
drop of blood. Wait for your result. (see diagram 06).
diagram 05
diagram 06

10. Your glucometer will display your results once completed. It’ll also automatically sync with
your smartphone when you hear a sound alert from your smartphone.
remote patient monitoring
by enable healthcare
Getting Started (cont’d)
Always keep smartphone plugged into charger.
This is not an emergency response unit. If you are experiencing any unusual
symptoms, please seek medical help immediately, or dial 911.
11. Discard the used test strip and lancet properly.
Make sure the phone is ALWAYS on charge.
Removing the phone from the charger can
lead to connection issues.
For additional assistance please visit www.
ehiehr.com/rpmpatients
If any issues occur, please contact RPM
support at 973-421-5222.
Important