Energy Save OUS 35 User manual

Installation manual for outdoor unit standing
Please check the package and make sure all the parts are inside. If anything
missing or damaged, please contact the local distributor.
φ φ6× 12
φ φ8.9× 31.7
1
Item no. Part name Quantity
!
1
2
3
4
5
6
User manual
Vibration damper
Leg
Horizontal bar
Metal foot
1
4
2
2
4
Note
7
8
9
10
11
Nut
Bolt
Expansion bolt
Spring washer
Small flat washer
Big flat washer
8
6
8
6
6
8
φ76
M8
M6×20
φ6
M6×60
φ60mm with M8 bolts in two sides
R120400221-V1.2
Adjustable height
571
526
350+ 27
460
unit:mm
Outlines and dimensions
●OUS 35

2
Installation
Note:
The ground surface should be level.
Make sure the ground surface can stand more than 5 times weight of the unit.
Fasten all the nuts of outdoor unit standing, to avoid any damage to the unit.
●
●
●
Install four metal feet to two legs, not fixed
very tightly.
Put two legs on the ground, and measure the
height of them. If they have different height,
adjust the metal feet to make sure all four metal
feet are in the same height, then fasten them to
the legs by wrench.
unit:mm
● OUS 35-50
352+ 27
552
695
736
Adjustable height

Put the two legs together. Adjust the width
until it matches the distance between the
outdoor unit feet.
Fasten the two parts of the horizontal bar with two
bolts and washers. Tighten them with a wrench.
Install four vibration dampers to the two
legs, fix them with washers and nuts
underneath.
Measure the distance between outdoor unit feet in
front and back side. Adjust the width of two
vibration dampers according to the distance.
Install two horizontal bars to each leg of the
standing with bolts. Tighten them with a
wrench.
Measure the distance between outdoor unit
feet.
3

Fasten the vibration damper to the leg with
M8 nut, with a socket wrench.
4
Mark on the ground where the installation
holes will be drilled.
Use a power drill with drill bit of diameter
8mm to drill the ground.
Put expansion bolts in the holes of ground. Put
the standing on the expansion bolts according to
the holes in the metal feet, and fix the standing
with a wrench.
Put the outdoor unit on the vibration
dampers of standings.
Fasten the outdoor unit to vibration dampers
with M8 nuts and washers. Make sure that you
have the required distance between the back of
the unit to the wall.