EnfaSafe FREEDOM 360 ROTATE User manual

IMPORTANT: PLEASE KEEP FOR FUTURE
REFERENCE. READ CAREFULLY
Instruction Manual

1
IMPORTANT: READ THESE
INSTRUCTIONS CAREFULLY BEFORE
USE AND KEEP FOR FUTURE
REFERENCE
If these instructions are not followed, the
safety of a child may be severely endangered.

2
CONTENTS
1. Notice
2. Warning
3. Parts labelled
4. Rear-facing installation:
Group 0+ (0-13kg) ISOFIX + top tether + harness
Group I (9-18kg) ISOFIX + top tether + harness
Rear-facing recline positions
5. Forward-facing installation:
Group I (9-18kg) ISOFIX + top tether + harness
6. Storing the harness
7. Forward-facing installation:
Group II (15-25kg) ISOFIX + 3-point seat belt
Group II (15-25kg) 3-point seat belt
Group III (22-36kg) ISOFIX + 3-point seat belt
Group III (22-36kg) 3-point seat belt
Forward-facing recline positions
8. Securing the child
9. Insert cushion
10. Maintenance
...............................................................................................3
........................................................................................4-5
................................................................................6-7
..............................................................8-10
............................................................11
........................................................................12
.......................................................13-14
.....................................................................15-16
.................................................................................17
.................................................................................18

3
Group 0+
Group I
Group I
Group II, III
0-13Kg
9-18Kg
9-18Kg
15-36Kg
ISOFIX + top tether + harness
(rear-facing installation)
ISOFIX + top tether + harness
(rear-facing installation)
ISOFIX + top tether + harness
(forward-facing installation)
3-point seat belt
(forward-facing installation)
1. NOTICE
Please read the instructions carefully, because improper installation
may cause serious injury, in this case, the manufacturer is not
responsible.
Use category
At the moment the car seat is suitable for children from birth to
36 kg (Gr 0 +, I, II, III, from birth to about 12 years of age.)
Group II, III 15-36Kg ISOFIX + 3-point seat belt
(forward-facing installation)

4
2. WARNING
This child restraint system has been approved under standard
ECE 44 04 to be used by children weighing between 0 kg and 36 kg.
Please do not leave the child unattended inside the vehicle.
Please read the instructions carefully .
Incorrect installation of the child restraint system could cause serious
consequences for the child.
In the case of incorrect installation the manufacturer is in no way
responsible.
It is approved under Standard 44 04 ECE for use in vehicles with the
ISOFIX anchoring system.
It may be installed in vehicles with approved ISOFIX positions
(as detailed in the manual from your vehicle manufacturer) depending
on the restraint system category and the space it takes up.
The mass group and the ISOFIX category for which this system is
approved from 0-13 kg and D, from 9-18 kg and B1.
Check your vehicle instruction manual to make sure that ISOFIX
category D, B1 child safety seats are suitable for your vehicle.
Protect the child restraint system from direct contact with sunlight, the
plastic and metal parts may heat up and burn the child.
Keep the child restraint system away from corrosive liquids, paints or
solvents that could damage the seat.
When the device is used in combination with an adult safety-belt to
be used by means of the following wording: Only suitable for use in
the listed vehicles fitted with 3 point safety-belts, approved to ECE
Regulation No. 16 or other equivalent standards.
The importance of ensuring that any lap strap is worn low down, so
that the pelvis is firmly engaged, shall be stressed.

5
It shall be recommended that any straps holding the restraint to the
vehicle should be tight, that any straps restraining the child should
be adjusted to the child's body, and that straps should not be twisted.
In the event of an accident the child restraint system should be
replaced, even if it is not visibly damaged. The product may have
internal damage that is not visible and that may compromise the
child's safety.
Stop for breaks on your journey so the child can walk about and play
out of the safety seat.
It is not advisable to travel for more than 2 hours without stopping for
a break. For babies this advice is particularly important.
The textile cover is an essential part of the child restraint system. It
must not be replaced by another cover without explicit authorisation
from the manufacturer.
Do not use the safety seat without the cover and the harness pads.
Make sure the child's fastening harness is fitted correctly and not
twisted at all.
It is advisable to move the front seat of the vehicle as far forward as
possible.
Do not alter the product, by adding or removing any of the
accessories.
Follow the product assembly instructions carefully.
Do not leave any luggage on the parcel shelf without securing it as in
the event of an accident it could cause significant injury to the
passenger in the vehicle.
The importance of ensuring that any lap strap is worn low down, so
that the pelvis is firmly engaged, shall be stressed.

6
3. PARTS LABELLED
1. Headrest
2. Flanks
3. Side energy absorber
4. Top tether
5. Buckle
6. ISOFIX
7. Headrest adjustment handle
8. Upper belt guide
9. 5-point harness
10. Tensor adjusting button
11. Tensor adjusting strap
12. Reclining button
13. Rotation button
4
6
8
5
9
10
11
12
13
1
2
3
7

7
3. PARTS LABELLED
14. Top tether guide groove
15. Lower belt guide
16. ISOFIX release button
17. ISOFIX status display
18. ISOFIX slide button
3. PARTS LABELLED
14
15
16
18
17

8
4. REAR FACING INSTALLATION
Group 0+ (0-13kg) ISOFIX + Top Tether + Harness
Group I (9-18kg) ISOFIX + Top Tether + Harness
If your vehicle is equipped with Isofix anchor points, these should be used
to obtain a more stable installation.
These cars will have plastic elements that guide the seat’s ISOFIX anchors
into their correct positions. If your vehicle does not have these guide
elements, you can use the plastic guides provided with the car seat.
4a. Press the button (13) to turn the seat to the rear-facing position.

4. REAR FACING INSTALLATION
4b. Slide the lSOFIX anchors B (6)
to their maximum length by turning
the level A (18). Do this on both
sides of the seat.
Connect the lSOFIX anchors until
you hear them “click” into place.
The display window on the button (17)
will turn from red to green.
Push the seat as far back as
possible. Make sure that both
lSOFIX are in the same position
once you have pushed the seat
back.
4c. Press and pull the button of regulator up and release top tether to
an appropriate length.
Put the top tether in one of guide grooves (14) on the shoulder.
Connect the Top Tether in the
anchor point intended
for this in the vehicle
marked with
the symbol:
9
A
B

10
4. REAR FACING INSTALLATION
4d. Lastly, tighten the strap of the Top Tether system until the green
signal is displayed on the indicator.
The strap should go over the backrest of the vehicle seat.
If necessary raise the headrest or remove it.
4e. Once the child is securely strapped in, you can recline the seat by
pressing the button (12).
Rear-facing (0-18kg) - Position 1 is allowed only.
0-18kg
Rear-facing
1
1
2 3 4
4
3
2

5. FORWARD FACING INSTALLATION
Group I (9-18kg) ISOFIX + Top Tether + Harness
5a. Press the button (13) to turn the seat
to the forward position.
Follow the same
step (4b) to install
ISOFIX.
5b. Connect the Top Tether in
the anchor point
intended for this in the vehicle
marked with the symbol:
Lastly, tighten the
strap of the Top
Tether system until
the green signal is
displayed on the indicator.
11
AB

12
6. STORING THE HARNESS
Once the child has reached a weight of 18kg the harness should be
stored away and the child should be secured with Option 1. ISOFIX
and the vehicle safety belt or Option 2. the vehicle safety belt only.
6a.To store the harness away it needs to be fully loose.
Remove the side cushions. Undo the press studs and hide the shoulder
pads underneath the cover.
6b. Remove the buckle padding. Thread the buckle through the cover and
under the cushion. Store the buckle parts in the
compartment under the cushion. Then fix the cover back on the seat.

7. FORWARD FACING INSTALLATION
Group II (15-25kg) ISOFIX + 3-Point Seat Belt
Group II (15-25kg) 3-Point Seat Belt
Group III (22-36kg) ISOFIX + 3-Point Seat Belt
Group III (22-36kg) 3-Point Seat Belt
7a. Group II III can be installed two ways:
ISOFIX + 3-Point Seat Belt
or 3-Point Seat Belt only
7b. Follow the same step (4b)
to install ISOFIX.
WARNING! Group II III installation
is Forward-facing only.
7c. Place your child in the car seat and make sure they are sitting well.
Thread the vehicle’s shoulder belt through the upper belt guide (8)
and the lap belt through the lower belt guide (15).
Lock the belt into the vehicle seat belt buckle
ensuring it “clicks” into place.
Make sure the belt is not too loose,
gently pulling the diagonal part
of the belt before placing the belt
over the child’s chest.
WARNING! Ensure the
belt is not twisted.
13
AB

7d . Once the child is securely strapped in, you can recline the seat by
pressing the button (12).
Forward-facing (9-36kg) - Position 1,2,3,4 is allowed.
14
9-36kg
Forward-facing
1 2 3 4
2 3 41

8. SECURING THE CHILD
This child restraint system has a loading position making it easy to
place the child in the seat and adjust the straps to fit correctly.
8a.Loosen the harness by pressing the button (10) and pulling the
diagonal part of the harness straps. Unfasten the buckle (5) by pressing
the red button. Move the ends of the buckle to each side of the seat
so you can put the child in the seat.
8b. Position the child in the seat
and place the strap over him on
the both sides, and then fasten
the buckle. To adjust the
headrest (1) pull the level (7)
on the top. It should be set to
the right position, this means
that the shoulder harness
should come out approximately 1cm
above the child’s shoulders.
Tighten harness by pulling the lower
strap A (11), it should fit the child snugly.
B
1cm
15

8. SECURING THE CHILD
8c. Once the child is securely
strapped in,you can recline the
seat by pressing the lever (12)
to the required position.
To get the child out of the seat, follow the same process in reverse (8b).
Please make sure that the child gets out of the vehicle on the pavement
side.
WARNING! Ensure the straps are not twisted.
WARNING! The harness buckle must be fastened correctly and
the straps should fit the child snugly.
16

9. INSERT CUSHION
9a. Use the complete insert cushion until the baby reaches 5kg.
9b. When the baby is 5-12kg, take off the inner headrest.
9c. When the child is 12-36kg, remove the complete insert cushion.
17
0-5kg 5-12kg 12-36kg

10. MAINTENANCE
Fitting / removing the cover:
The cover of the car seat is very easy to remove. There are 2 fastening
points for the cover on the front. Simply unfasten these points and then
gently pull the front part of the cover.
On the sides of the seat there are some plastic parts that are used to
fasten the cover. Simply pull these gently to remove the cover.
To put the cover back on again just follow the same process in reverse.
Fit the parts into the slots for the sides.
Cleaning:
The cover can be machine washed using mild detergent and at a
maximum temperature of 30°C. Please see the washing instructions on
the care label of the cover.
Do not tumble dry as this could cause the padding to come away from
the fabric. Do not expose the upholstery to sunlight for prolonged periods,
when the seat is not in use. Cover it up or store it in the vehicle boot.
The plastic parts can be cleaned with a damp cloth and neutral detergent.
Recommendations:
Keep this instruction book for future reference. Always store it in the
compartment in the back of the car seat shell.
In the vehicle make sure that all luggage, as well as any other object that
could cause injury in the event of an accident, is correctly secured or
stored.
18