eNNOVEA VitaCarry Guide

Care and
Use Guide
Advanced Pill Grinder
Grinds pills to powder
with the push of a button.
VitaCarry
Advanced Pill Grinder
life
®

This product is designed for grinding
&
Before grinding ANY medications
or supplements, ALWAYS
this product for
capsules
capsules
or
POWDER BASED PILLS TABLETS ONLY
CONSULT YOUR PHYSICIAN
DO NOT USE
LIQUID FILLED
HARD COATED PILLS
TIME RELEASE
WARNING
To reduce the risk of injury, everyone using
this tool must read and understand these
instructions before operation. Never put
fingers near gears while operating. Keep loose
clothing, long hair, etc. away from entry.
Easy Set Up
Install 3 AAA batteries
(not included) in battery
compartment as shown.
Congratulations on the purchase of your new Advanced Pill
Grinder. Please familiarize yourself with its’ safe operation and
features before you begin to use it. This product is for adult use
only. Keep away from children.

Top Cover
Power On/Off
Safety Tab
Collection
Tray and
Bottom
Cover
Cutting Gears
w/viewing window
Do not bend or break.
Unit will NOT operate
w/Top Cover removed.
Always be sure this
thumb nut is secure
before operation.
Features
Getting to
know your
new Pill Grinder
Inner Cover
Trim
Strip

Remove Top Cover
Insert 1 or 2 pills
by gently sliding forward
and lifting.
in the cavities on either
side of the white bar.
DO NOT FORCE THEM
Pills should not extend
above the top surface.
Split them first if they
are too big.

Operation
Replace Top Cover
Press Power Button to Grind
Note
by carefully aligning Safety
Tab and sliding in place until
you hear a click.
w/Bottom Cover removed to distribute
ground pills where you want them
w/Bottom Cover in place to grind
and re-grind to ultra fine powder
w/Collection Tray in place to
grind and collect grounds
for distribution later
press Power Button when done
and the gears will continue to turn
until they are aligned in an optimal
position for the next use.
DO NOT OPEN COVER with gears turning.

Cleaning Remove | Replace
Inner Cover
Remove Inner Cover
by sliding forward and lifting.

Cleaning
Remove Cutting
Gears
Remove Cutting Gears
Remove Trim Strip
Caution
by gently lifting w/Trim Strip
removed. To replace, align
carefully where keyed.
by sliding gently forward and
replace when Cutting Gears
are cleaned and seated properly.
Clean Cutting Gears
and Collection Tray and
Bottom Cover by rinsing
unit with soap and water
or simply putting parts in
the dishwasher.
it is NOT necessary
to disassemble the
Cutting Gears.
Always keep thumb
nut tight for operation.

eNNOVEA, LLC
2030 Dividend Drive
Columbus, OH 43228
[e-mail]
www.ennovea.com
© eNNOVEA, LLC
VitaCarry is a US registered trademark.
Designed in USA. Made in China.
®
Manufacturer’s Limited Warranty
eNNOVEA LLC will repair or replace any
product that fails to operate as promised as a
result of defective materials or assembly for a
period of one year. Damages caused by mis-
use, negligence or accidents are not covered
under this warranty. Item should be returned to
eNNOVEA, LLC with proof of purchase,
postage prepaid and description of problem.
Tested to comply
with FCC standards
life