Epson Livingstation LS57P1 Owner's manual

Installing and Maintaining the Optional
Front Air Filter
Follow these instructions to install and maintain the optional front air filter for your Epson®LivingStation®television.
This filter is intended for customers who live in dry, dusty areas to reduce the amount of dust that enters the TV.
Caution
Once the new air filter has been installed, you need to clean it periodically as described on the next page. Failure to clean the filter
may cause the TV to overheat. If the TV gets too hot, it may turn itself off for protection.
Installing the Filter
Follow these steps to install the new filter:
1Remove the right speaker cover. Grasp the cover and pull it straight off.
2Remove the adhesive backing from the filter.
HDTV LCD Projection Television
®
Remove cover
Remove adhesive backing

3Align the slot in the filter with the tab on the TV. Press the filter in place over the air intake vent.
4Press down on the filter to make sure the adhesive is secure.
5Replace the speaker cover.
Cleaning the Air Filter
Once the air filter is installed, you need to inspect it regularly. If the filter appears to be dirty, clean it as described below.
Note
Whenever you inpect the front air filter, you should also check the air filter on the left side of the TV and clean it if necessary. The
location of this filter is shown in your User’s Guide. You can clean the side filter using the same method that you use to clean the
front filter.
1Remove the right speaker cover.
2If the filter looks dirty, clean it using one of these methods:
• Use a computer vacuum cleaner or the upholstery brush attachment for your home vacuum cleaner to lightly
vacuum the filter and remove the dust. If your home vacuum cleaner has an air bleed valve (located near the
end of the hose where you attach the cleaning tools), you should open the valve to decrease the amount of
suction.
• Use a clean paintbrush with very soft bristles to lightly brush off any dust from the crevices.
3Replace the speaker cover.
Epson and Livingstation are registered trademarks and Epson Exceed Your Vision is a trademark of Seiko Epson Corporation.
© 2007 Epson America, Inc. 7/07 CPD-24509
Align slot with tab on
air intake vent
Make sure adhesive
is secure