ERGOMART EQP3418 User manual

Non-tilt base
Forearm
2 - Friction Joint
1 - Friction Joint
3 - Friction Joint
Step 1 Attaching the Arm to the Mount
Before beginning, please be certain that the mount is secure on the
surface. Insert the shaft of the arm assembly into the mount.
Remove platform from wrap. Unscrew the four 1/4” x 20 Philips flat
head screws from the tilt or non tilt base found at the end of the
forearm. Place the platform on top of the non tilt base, line up the
screw hole pattern and replace the screws and tighten.
Step 2 Attach Monitor Platform to the Arm
EQP3418 CRT Monitor Arm
Installation Instructions
Ergonomic solutions for office and light industrial work environments
©2017 Ergomart. All rights reserved.
A - Counter-Balance - Arm must be fully loaded with CRT before
attempting to adjust gas spring Cylinder.
With the CRT monitor on the platform, push the arm into a horizontal
position, insert the 1/4” allen wrench.
To increase the strength, turn the wrench left (counter-clockwise). To
decrease the strength, turn the wrench to the right (clockwise).
When the arm does not drift up or downward, your adjustment is set.
Step 3 Adjustments
WARNING - Lifting arm must be pushed down or lifted up into a horizontal position to makeadjustments.
B - Friction Joints
Friction joints are found in the (1) mount, where the (2) forearm
elbows with the main body of the arm and (3) where the platform
attaches to the end of the forearm.
Insert the 3/32” allen wrench into the set screw and tighten or loosen
to the desired degree of friction. (Left to loosen - Right to tighten).
www.ergomart.com | 888 420 3200

EQP3418 CRT Monitor Arm
Installation Instructions
Ergonomic solutions for office and light industrial work environments
©2017 Ergomart. All rights reserved.
Trouble-shooting & F. A. Q.
Q. How does the monitor platorm tilt?
A. Depending on the monitor platform you selected, platform tilt may not be available.
Q. Why can’t I push my arm down into the horizontal position?
A. The monitor must be on the platform for the arm to move.
Q. The friction joints do not loosen/tighten.
A. Be certain that you are turning left (counter-clockwise) to loosen and right (clockwise) to tighten. (Opposite
of counter-balance adjustment).
Q. Why does the arm drift upward/downward after the counter-balance has been set?
A. This will happen if the mount is not perfectly level. A good rule of thumb is to keep the mount joint loose
while the platform forearm joint is snug.
Q. Can I download these instructions?
A. All product instructions are available on our website; www.ergomart.com
Q. How do I return my monitor arm?
A. You can obtain a return authorization number (RMA) by contacting our customer service department at
888 420 3200 All returned items must be accompanied by an RMA.
Your assembly and modifications are complete. If you need additional assistance regarding this product please
contact our customer service department at 888 420 3200.
www.ergomart.com | 888 420 3200