Essence Premium 600 User manual

16mm R/Head Screw 2
2. Inserting Cams
1. Fitting Cams, Cam Pins, Brackets and Dowels
600 FLOOR STANDING UNIT
Back
Door
Plinth
End Panel RH
CAUTION: Some Fittings are small enough to choke a child.
NOTE: Any additional components left after assembly maybe required for installation-do not discard.
appearance of the units dust regularly with a soft cloth. For grime stains wipe with soft damp cloth using a mild detergent.
discarding any packaging. Lay panels on smooth level surface using outer packaging to protect the finish. To maintain the
PLEASE READ. Carefully open the packs supplied and check the contents against the Panels and Fittings checklist before
Bottom / Shelf
Rebated Rail
16
'L' Bracket
11.
12.
2
Handle Inc Bolts
1/2
1
1
2
1
1
2
1
7.
6.
5.
4.
back of the Hinge Assembly to detatch the plate.
Hinge Assembly
12mm C/Sunk Screw
4
13.
8.
Dowel
End Panel LH
16
10
Cam
Cam Pin
14.
15.
8
10.
9.
1.
2.
3.
Insert all Cams (8), Cams Pins (9) and Dowels (10) into both of the End Panels
(1/2) and the Plinth (7). Fix the 'L' Brackets (12) using the 16mm Screw (11).
Screw the Hinge Plate (13) using the scews supplied. Push the button at the
2
Insert all Cams (8). Point Cam arrow towards the intersecting Cam hole.
3
3
4
5

8
5
2
3. Assembling the Unit
8. Handles
the Handle Bolts supplied.
panels. Fix the Handles (15) onto the door panels using
shown. Turn the CAMs (8) to tighten the panels together.
6. Hinges and Hinge Adjustment
Locate the panels by inserting the CAM Pins (9) into the respective holes in the positions as
the 12mm C/Sunk Screws (14).
CB A
Fix the Hinge Assembly (13) to the Doors (6)using
Drill a 5mm hole through the top two holes in the door
4
Adjustments apply when door is mounted.
3
1
3
A. Adjusts door vertically
B. Adjusts door horizontally
C. Adjust door in and out
7. Mount Doors
Attatch the Hinges (13) to the Hinge Plates (13) on
both of the End Panels (1/2). Do this by locating the
hooks on the front face of the hinge plate and press
down until it clicks into position.
A
172001