Essential Garden S-778N User manual

owner’s
manual
Date of purchase: _____/ _____/ _____
Product code: 7-8002559960-6
UPC code: 769455757937
Vendor Item: S-778N
Claremont Dining Table
1

PARTS
Read through all the instructions before beginning assembly. Unpack and identify all the parts.
Place them on a flat, non-abrasive surface. Assembly by two people is recommended.
A (1)
Tempered Glass
Tabletop
C (1)
Metal Center Ring
ACCESSORIES
Da (1 spare)
Bolt
Dc (1 spare)
Metal Washer
Dd (1)
Umbrella Insert
B (4)
Metal Leg attached
with 2 Bolts and 2
Metal Washers
for each
Db (4)
Screw
De (1)
Allen Wrench
Df (1)
Assembly
Instructions Sheet
owner’s
manual
Date of purchase: _____/ _____/ _____
Product code: 0-00000000-0
UPC code: 000000000000
PACIFICCOVE 42"ROUNDTABLE
2

Made in CHINA for Kmart Corporation, Hoffman Estates, IL 60179
SHOP kmart.com
See our extensive assortment of outdoor living products
on-line at www.sears.com and www.kmart.com
For questions or comments about product:
Call toll-free: 800-457-4652
Please refer to part numbers when reordering
ASSEMBLY INSTRUCTIONS
Your table is now ready for use. Enjoy!
1
2
4
5
CARE INSTRUCTIONS
Wash with a mild solution of soap and water; rinse thoroughly. Dry completely. Do not use bleach or solvents.
Cover furniture with outdoor furniture covers when not in use.
Place the tempered glass tabletop (A) upside down on
a non-abrasive worksurface. Insert four metal legs (B)
into the plastic receivers of the tempered glass
tabletop (A). Place the metal center ring (C) between
the metal legs (B), for each hole insert a bolt (Da)
through a metal washer (Dc), through the metal center
ring (C), secure into the metal leg (B). See Fig. 1. Do
not tighten completely.
Remove all components from the carton and place on
a flat surface. Remove all bolts (Da) and metal
washers (Dc) from legs. Count and identify all parts.
Securely tighten all bolts by using the Allen wrench (De).
Turn the table over and press the umbrella insert (Dd)
into the center umbrella hole.
Adjust the metal legs (B), align the holes on the
metal legs (B) with the holes on plastic receiver of the
tempered glass tabletop (A). For each hole insert a
screw (Db) through the plastic receiver and secure into
the metal leg (B). Tighten all screws (Db) completely.
See Fig. 2.
3
A
B
C
Dc
Da
Db
3
Fig.1
Fig.2