EUROCOM Sky X9C User manual

P870DM3 to P870TM1 Conversion Guide

Tools Required
1. Container to hold screws
2. Large and small Philips screwdrivers
3. Exacto knife
4. High quality thermal paste
5. Cloth for cleaning thermal paste
6. Contact cleaner, or isopropyl alcohol

Part 1: Preparing the P870TM1 For install
Step 1. Remove the 9 screws holding
the bottom cover on
Step 2. Remove the Bottom Cover

Step 3. Remove the GPU heatsink by
removing the 4 screws.
Set aside
Step 4. Remove the CPU heatsink, by
going from number 7 to 1, disconnect
CPU fan.
Set aside.
Verify that there is no screw in the
hole mark KB.

Step 5. Open CPUretention clip.
Step 6. Carefully install CPU.
Make sure it is flat.

Step 7. Close CPU retention clip
Step 8. Apply and spread high quality
thermal paste.

Step 9. Install CPU heatsink, follow the
number pattern from 1 to 7.
Plug in CPU Fan.

Part 2: Removing parts from P870DM3
Step 1. Remove the 9 screws holding
the bottom cover on
Step 2. Remove the Bottom Cover

Step 3. Remove the 4 screws and
remove the battery.
Remove K/B screw
Step 4. Push large screwdriver in hold
between CPU fan and subwoofer

Step 5. Lift keyboard from top near
LCD and place on palm rest.
Be careful, there are 3 cables
attached.
Step 6. Disconnect 3 keyboard cables,
and remove keyboard.