Page 5 of 21
Introduction to the ungee trampoline.
This spectacular fun-device can be enjoyed by all ages, allowing all skill levels to partake
in the experience, acrobatics (if competent) and the exercise that build confidence and
aids development
The bungee trampoline comes complete with all major components :
Aluminum-steel construction
8 big tubes (4 legs and 4 arms)
4 small tubes (the vertical supports between the legs and the arms)
4 winch motors
4 trampolines
4 sets of elastics
Ropes, pulleys and carabiners
Tensioning steel cables
4 Bungy-Trampoline-Harnesses (1 L, 1 M, 1S , 1 XS)
Assem ly
You can find the photographs relating to the assembly on the last pages, showing the
step by step assembly of the bungee
Preliminary:
Carry out an assessment of the site
The site should be level
The surface must not be slippery,
Any maneuvering vehicle must be guided by a banksman
The public must be kept clear during maneuvering and assembly
Step 1: Place the unit on level ground in a position that faces the crowd and pedestrian
traffic flow, and insure that you have sufficient overhead clearance to operate the unit
(no overhead electricity cables within 8m of any part of the device) or obvious obstacles
that might impede the jumper using the device
Step 2: Raise the main mast and set it up in position on the base cross so that the
other tubes can be connected;
Step 3: On the main mast there are profiles where the leg supporting tubes should be
connected and secured with pin fastenings;
Step 4: At the bottom of the legs insert the metal base plates and secure with the bolt
Step 5: Connect the chains to the metal cross under the main mast;
Step 6: Connect the tensioning cables between the base plate on the end of each leg
and cross under the center mast;
Step 7: Connect one end of the arm tubes to the main mast and secure with the bolt;
Step 8: Connect the “alpin” ropes to the end of the arms;
Step 9 - 10: Connect all steel cables to the eye bolts on the end of the arm pole
Connect the pulleys to the eye bolts Connect the 80 mm pole to the arm tube and
secure with the bolt Using the 80 mm tubes, lift the arms and place the bottom of the
80mm tube on the fixing on the supporting leg;
