Eurotramp DMT User manual
Assembly instructions DMT oor mount
Parts list:
• 12mm Plywood panel 1850x3250mm (Fig.1)
• 8 pc. Mounting block type 1 (Fig. 2)
• 4 pc. Mounting block type 2 (Fig. 3)
• 76 pc. Wood screws 3.5*25 (Fig. 4)
• 5m² (z.B. 4*50mm roll of 25m EAN 4042448388704) double-sided tape
1
2
3
4
Process:
• Cover one full side of the plywood panel with the tape (e.g. in long strips).
Panel must be clean.
• Thoroughly clean the surface on which the DMT will be placed
(free from dust and grease).
• Pull the protective backing off of the tape and adhere the panel to the
clean surface.
Process:
• Align the Doppelmini Trampoline to the plywood panel and set it at
the specied height relative to the oor (not the wood panel).
• Check the chain tension and adjust if necessary.
• Screw 2 pc. Type 1 mounting blocks onto the front and rear feet from above
as pictured. The foot protector of the trampoline should be surrounded as
closely as possible without play. (Fig. 5)
• Use the Type 2 mounting blocks to x the centre feet to the front and rear.
Assembly instructions DMT oor mount
Note:
• If the panel will be attached to a wood surface (e.g. wooden platform),
the adhesive is not necessary and the panel can instead be screwed into
the subsurface. Longer screws can also be used in the mounting blocks.
• The plywood panel is designed for one-time use and will be difcult to
remove from the oor without damaging it.
• The mounting blocks are designed for reuse.
Alternatives:
• If a plywood panel in the correct dimensions is not available, 2 panels can
be placed together to create the correct size.
• If no Eurotramp mounting blocks are available, simply use square timber.
Ensure the screws are the correct length and do not penetrate the subsurface.
Table of contents
