Eurotramp 40000 User manual

1
Eurotramp - Trampoline Kurt Hack GmbH
Use, Maintenance and Assembly Instructions
General data ...................................................................................................................................................... 1
Maintenance recommendations........................................................................................................................ 1
Parts list............................................................................................................................................................. 2
Installation draf Freestyle Fivesquare Trampoline .............................................................................................. 3
Assembling the frame ....................................................................................................................................... 4
Jumping bed assembly...................................................................................................................................... 6
Attaching the banners........................................................................................................................................ 7
Frame padding installation................................................................................................................................. 8
Freestyle Fivesquare disassembly..................................................................................................................... 8
Freestyle Fivesquare Trampoline (Art.-No. 40000 / 40001)

1
Eurotramp - Trampoline Kurt Hack GmbH
Art.-No. 40000: Freestyle FivesquareTrampoline
• Frame dimensions: 556 x 556 x 150 cm
• Total weight: 595 kg
• Frame pad colour black
Not foreseen for outdoor use!
The trampoline must always be examined for possible damages before use. Particularly make sure that pads, the
jumping bed, springs and frame parts do not display any damages. Damages must be addressed immediately. In
case of any doubt about whether the apparatus is functional, a specialist advice should be sought (e.g., from the
manufacturer)
Check the following regularly:
• Padding
• Jumping bed
• Springs / Rubber cables
Check the apparatus before use and replace all defective or missing parts. Pay particular attention to the following:
• No damages to the jumping bed;
• jumping bed suspension in perfect condition;
• frame does not display any cracks or other damages;
• springs / rubber cables are not damaged or over-extended;
• full frame padding cover is attached properly;
• over-extended and tired springs / rubber cables are to be replaced;
• the important thing is that the springs are always hooked in with the eyelet pointing downwards.
General data
Maintenance recommendations
Number of users
The Freestyle Fivesquare may only be used by one person at a time. Other persons should therefore not remain
on the trampoline. The exceptions to this rule are coaches or assistants providing support to the gymnast when
performing exercises. Use of the Freestyle Fivesquare trampoline is only permitted under supervision.
Safety room
Make sure that the trampoline is only used in a safe environment covered by at least 2 m wide gym mats framing
the trampoline.
Installation details
The trampoline is demounted when it is delivered. It will be installed on-site ready for use by a quali ed staff
ordered by the dealer. There should be suf cient people who help to get the trampoline down off the truck and
carry it to the nal location.
Art.-No. 40001: Freestyle FivesquareTrampoline
• Frame dimensions: 556 x 556 x 150 cm
• Total weight: 595 kg
• Frame pad colour grey

2
Eurotramp - Trampoline Kurt Hack GmbH
Parts list (scope of delivery)
All spare parts available from Eurotramp upon request.
The very highest demands are placed on this high-end-product. For safety reasons, only use original replacement parts! The use
of non-original replacement parts can result in considerable risk to the user (danger of accidents, technical defects, loss of the
manufacturer’s liability, loss of warranty etc.).
!
Freestyle FivesquareTrampolin Quantity
Frame part 4
Leg 150 cm hight 4
Leg brace 8
Steel cables 4
Grub srews M12x20 16
Jumping bed made of polyester fabric, 412 x 412 cm 1
Steel springs 164
Anchor bars 160
Rope loop 3 mm 160
Frame pad 8
PVC straps 4
Velcro roll 2
Spring clip 16
Mounting tool 2

3
Eurotramp - Trampoline Kurt Hack GmbH
12 3 456 7 8
F
23 4 5 67 81
A
B
C D
E
A
B
C
D
E
F
Datum Name
Bearb.
Gepr.
Maßstab Werkstoff
Rohteil/Halbzeug/Ausgangsteil
Benennung:
Copyright by Eurotramp. All right reserved. Referred to protection notice ISO 16016
Ähnlich: Ers. für:
Zeichnungs - Nr.:
Model - NR.:
Name
Datum
Änd - Nr.:
Ä-Ind
Blatt:
Eurotramp-Trampoline
Kurt Hack GmbH
conrad27.10.2016
5²
Zusammenbau
5²Zusammenbau
PLOTUSER 00.00.0000
1
1
Blattgröße: A3
/
5560  30 Rahmen / frame
5560  30 Rahmen / frame
1500  10 Rahmen / frame 200 Polster / padding
4060 Tuch / jumping bed
4060 Tuch / jumping bed
12 3 456 7 8
F
23 4 5 67 81
A
B
C D
E
A
B
C
D
E
F
Datum Name
Bearb.
Gepr.
Maßstab Werkstoff
Rohteil/Halbzeug/Ausgangsteil
Benennung:
Copyright by Eurotramp. All right reserved. Referred to protection notice ISO 16016
Ähnlich: Ers. für:
Zeichnungs - Nr.:
Model - NR.:
Name
Datum
Änd - Nr.:
Ä-Ind
Blatt:
Eurotramp-Trampoline
Kurt Hack GmbH
conrad27.10.2016
5²
Zusammenbau
5²Zusammenbau
PLOTUSER 00.00.0000
1
1
Blattgröße: A3
/
5560  30 Rahmen / frame
5560  30 Rahmen / frame
1500  10 Rahmen / frame 200 Polster / padding
4060 Tuch / jumping bed
4060 Tuch / jumping bed
Installation draft Freestyle Fivesquare Trampoline

4
Eurotramp - Trampoline Kurt Hack GmbH
• Put the legs of the frame 5.5 m apart from
each other on the ground as shown.
• The hooks should face the inside of the
square whereas the two round
sleeves face downward.
• Slide two legs into one lying side frame part,
lift the premounted side frame part and use a
safe support to prevent from falling.
1
2
3
Required material
• Safety gloves (not in scope of delivery)
Assembling the frame
The assembly should preferable be done by 3 persons.
• Slide another side frame part into one of the
upright legs and support it with the third leg.
• To mount the remaining part you need to pull
apart the frame by a little. It might be helpful
not to slide any of the frame parts all the way
in at rst.

5
Eurotramp - Trampoline Kurt Hack GmbH
• Mount the steel cables to the chain links on
the legs.
• Do not tigh the steel cables yet!
• Mount the legbraces to the round sleeves.
• Tight the screws.
4
5
6• Tighten the steel cables „hand-tight“ with the
turnbuckle and tighten the lock nuts.

6
Eurotramp - Trampoline Kurt Hack GmbH
The jumping bed should preferable be attached by 2 persons.
• Install the jumping bed with two springs on
each corner. The graphics of the bed should
face upward.
Required material
• Mounting tool
• Safety gloves (not in scope of delivery)
1
2
3
• Hang in 2 steel springs per corner rst of all to
x the jumping bed.
• Install the hooks to the jumping bed and
always put a rope loop in the middle of each
hook. Put three webs on each side of the
hook. Only in the corners there will be 4 webs
on one side of each last hook. If the loop of
the very last web is too small it
can be neglected.
Jumping bed assembly (with the graphics side facing up)

7
Eurotramp - Trampoline Kurt Hack GmbH
4
5
6
• Hook the springs onto the jumping bed.
• Then hook the springs - parallel side - with the
mounting tool onto the frame rst.
• Always hook the springs on opposite sides
in at the same time to prevent unnecessary
excess tension on the springs.
• Attacht the remaining springs.
• Here also hook the springs on opposite sides
in at the same time to prevent unnecessary
excess tension on the springs.
Attaching the banners
• Remove the foil on the supplied Velcro and
attach on the at surface on each side of the
frame (close to the outer edge) and x the
banner on the Velcro.
Put the round steel bars into
both sides of the hemstich
in the lower side of the
banner.
1
!
!
Attention: the
spring ears should
point downwards!
Attention: the purchase of the banner is optional.

8
Eurotramp - Trampoline Kurt Hack GmbH
Frame padding installation
Freestyle Fivesquare disassembly
• The complete disassembly of the Fivesquare is to be
made in reverse order of the assembly.
1
2
3
• Install the pad lifter springs to the marked
hooks (8 on each side). In certain cases it can
be helpful to unmount the spring before
installing the pad lifter.
• Place the pad on one corner and apply light
pressure to x it to the frame.
• Cover the abutting ends with the black PVC
straps.
Always leave a spring
between the spring
clip leg.
Done!
!
!
Attention: never connect the
padding to the juming bed.
If you have any questions, contact us
any time:
EurotrampTrampoline - Kurt Hack GmbH
Zeller Str. 17/1 | 73235 Weilheim
+49 (0)7023 - 9495-0
[email protected]
www.eurotramp.com
www.eurotramp.com/utilitylms.d/9/
Assembly video