Event Lighting SPLIT124 User manual

SPLIT124
4-ways DMX Splitter
USER MANUAL
For safety, please read this user manual carefully before initial use.
Event Lighting reserves the right to revise the manual at any time. Information and specifications within this manual are subject to
change without notice. Event Lighting assumes no liability or responsibility for any errors or omissions. Please consult Event Lighting
for any clarification or information regarding this item.
www.event-lighting.com.au V1.

www.event-lighting.com.au
1
Safety Instructions
WARNING
•Do not open this device, there is no user-serviceable parts inside. Risk of electric shock.
•Do not operate this device outdoors or in any location where dust, excessive heat, water, or humidity may affect it.
•Do not connect this device to a dimmer or rheostat.
•The maximum ambient temperature is 104° F (40° C). Do not operate this device at higher temperatures.
Product Description
The SPLIT124 is a rack mountable and truss mountable DMX splitter designed to optically isolate and distribute a DMX
signal into 4 outputs in addition to the thru port with both 3 and 5 pin XLR connectors.
Mounting
Rack
The SPLIT124 has 4 holes on the rack ears that match a 1RU rack mounting.
Hanging
The SPLIT124 has 1 M10 threaded hole on the rear panel (bolt not included) to allow a hanging clamp to be bolted to
the unit.
The rack ear holes allow for a safety wire to be attached.
IOs
In
The SPLIT124 has both 3 and 5 pin ‘IN’ connections, both connections are in parallel so either can be used
independently.
Thru
The SPLIT124 has both 3 and 5 pin ‘THRU’ connections which are in parallel with the ‘IN’ connections and both can be
used simultaneously

www.event-lighting.com.au
2
Out
The SPLIT124 has both 3 and 5 pin ‘OUT’ connections for each output 1-4 which can be used simultaneously. These
outputs are optically isolated and re-transmitted for maximum range.
TECHNICAL SPECIFICATIONS
DMX512 protocol
Power: 100-240V AC 50/60Hz, 3W @ 120V AC 60Hz, 5W @ 230V AC 50Hz
Connections: 3 and 5 pin XLR input and outputs
Dimensions: 483 x 131 x 45 mm (1RU)
Weight: 2.6kg
WARRANTY
Please refer to your local dealer or please contact Event Lighting.