Evergreen Wind & Weather Solar Blossom Spinner User manual

Item #: ZH47M4073/ ZH2SP7944/ ZH2SP7945/ ZH2SP7946
Product Name: Solar Blossom Spinner
Outside Use Assembly time: 1 adult 20 minutes
Assembly Instructions
Step 1. To assemble the Decorative Spinner Head, slide Spinner (J) onto one of the
threaded ends of the T Bar (E). The side of the Spinner with solar panel grids should be
facing outward, with the side with the back of the solar housing facing the T Bar. Next, slip
on one of the tubular Spacers (L) and thread one of the Nuts (F) onto the T Bar and
tighten with the Wrench (I) to secure the Spinner. Slip one of the flat Spacers (J) onto the
exposed thread of the T Bar so it covers the Nut (I) and add one Split Ring Lock Washer
(M) and one Cap Nut (H) to secure the Spacer, again tightening with the Wrench (I).
To add the other Spinner, repeat the above steps, sliding on Spinner (K), solar panel grids
side facing outward, slipping on tubular Spacer (L) and threading on Nut (F), tightening with
wrench. Add flat Spacer (G), Split Ring Lock Washer (M), and Cap Nut (H), tightening with
wrench.

Step 2. To assemble the Stake Pole, slide the Double Prong Stake (B) onto the Ground Stake
(A), then thread the Extension (C) onto the Ground Stake (A), and thread Spinner Mount (D)
onto Extension (C). To ensure pole sections remain securely connected, insert the 4 Screws
(N) into the aligned holes at each section, using a Phillips Head screwdriver (not included).
Step 3. Finally, place the assembled Decorative Spinner Head onto the Spinner Mount (D), and
install the Spinner in a choice location. To install, push the three stakes into the ground,
softening with water if needed to make it easier to drive the stakes in. Use care not to over
saturate the ground.
BATTERY REPLACEMENT:
1. Remove the spinner blades from the T-bar.
2. Remove 3 inset screws on backside of solar panel (screws
A, B and C). Do NOT remove screws holding metal blades
to plastic compartment.
3. Once screws are removed, remove the cover on the front
of solar panel.
4. Replace the old battery. Install only new batteries of the
same type. Failure to insert batteries in the correct
polarity may shorten battery life or cause leakage.
5. Replace cover, aligning the screw holes with the posts and
secure it with screws.
6. Battery must be recycled or disposed of properly. Do not
short circuit or dispose of in fire.
© Evergreen Enterprises, Richmond, VA 23225
www.myevergreen.com
Made in China