Homebase BBQ GAZEBO User manual

Powder-coated steel frame
Includes 1 x gazebo
H260 x W250 x D150cm
BBQ GAZEBO
INSTRUCTION MANUAL
IMPORTANT: Please read these instructions before using the product. Retain instructions for future use.
HHGL Limited, MK9 1BA HHGL (ROI) Limited, D02 X576

2
Please read these instructions fully before starting assembly.
Check you have all the components and tools listed on page 3, 4 and 5 .
Remove all fittings from the plastic bags and separate then into their groups.
Keep children and animals away from the work area; small parts could choke if swallowed.
Make sure you have enough space to lay out the parts before starting.
Do not stand or put weight on the component parts and product, as this could cause damage.
Assemble the item as close to its final position as possible.
Assemble on a soft, level surface to avoid damaging the unit or your floor.
Parts of the assembly will be easier with two people.
We do not recommend the use of power drills/drivers for inserting screws, as this could
damage the unit. Only use hand screwdrivers.
Dispose of all packaging carefully and responsibly.
Only clean using a damp cloth and mild detergent; do not use bleach or abrasive cleaners.
From time to time, check that there are no loose screws on this unit.
This product should not be discarded with household waste. Take to your local authority waste disposal.
Domestic use only.
ATTENTION: To avoid damage, disassemble the gazebo during bad weather, e.g. during high wind or heavy rain.
This product is intended to be used as a temporary shelter and is not designed to be used as a permanent structure.

Please check you have all components listed below. If you have any missing or damaged components
please contact your local store.
3
Ax 2
Cx 2
Ex 4
Gx 2
Ix 1
Mx 1
Bx 2
Dx 2
Fx 2
Hx 4
Jx 6
Nx 1

4mm Hex key (included) 10mm Nut wrench (included)
4
X1 X3
XX4
Please check you have all fittings listed below. If
you have any missing or damaged fittings, please
contact your local store.
Note: The quantities below are the correct amount
to complete the assembly. In some cases, more
fitting may be supplied than required.
M6 x 15mm Bolt x 38 M6 x 30mm Bolt x 6
M6 x Metal nut x 6 Nails x 8

5
Attention:
Make sure that each bolt needed for all steps matches the corresponding figure to ensure
proper assembly.
2