Expedition One Universal Tire Mount User manual

INSTALLATION GUIDE
U N I V E R S A L T I R E M O U N T

NOTE
We highly recommend customers wait until they have the product in hand to schedule installations. All cancellations are
required in writing and will incur a 10% re-stock fee and any applicable packaging and shipping fees. Please review terms and
conditions for details.
•A narrow wheel with an extreme positive offset and a very wide tire may not work with the standard tire mount
•May NOT work with all patterns, wheels, or lug combinations or aftermarket wheels
•Holds up to a40" tire with certain wheel/tire combinations recommended size: up to a37" tire
(May Vary By Vehicle)
•This product contains chemicals known to the state of California to cause birth defects or other reproductive harm. For
more information go to www.p65warnings.gov

HARDWARE
TIRE MOUNT
HARDWARE
1/2”-13 X 1 1/4” HEX CAP 4
1/2”-13 NYLOC NUT 4
1/2” USS WASHER 8
3/8”-16 X 1 1/4” HEX CAP 4
3/8”-16 NYLOC NUT 4
3/8” USS WASHER 8
VEHICLE DEPENDENT –METRIC 12 OR 14
STUD 3
LUG NUT 3
TEAR DROP SPACER 3
LARGE WASHER (FOR STUD PRESS IN) 1CARRIER MOUNT

BOLT PATTERN
NOTE - May NOT work with all patterns, wheels, or lug combinations or some aftermarket wheels

PRESS IN STUDS
NOTE
- Studs can be pressed in using a press
- Manually by putting the stud through the opening and placing the lug upside down with
the large washer over the threaded end. Screw the wheel nut on with an impact, it will
suck the stud through The are various forums, websites and how to videos (YouTube) on
this. It is RECOMMENDED that you read or watch these before installing your lugs this
way. Incorrectly installed lugs or damage during the install will NOT be warrantied
- Use the provided tear drop spaces on the press in side to counter shallow offset wheels.

INSTALLATION
TIRE CARRIER ASSEMBLY
- Assemble the tire mount as shown by sliding the tire carrier over the top of the swing arm
mount loosely mount with the 1/2” hardware as shown below. Mount in the desired
position on either swing arm using the 3/8” hardware provided.
1
NOTE
Tire mount position is dependent on tire and wheel size
and providing clearance for any hardware, accessories or
OEM vehicle features sure as lights. Test fit or check for
any interference before mounting.
DO NOT mount the tire high or past the top of the arm.

Mounting the tire carrier to high may result in damage and will NOT be warrantied. Mount as low on
the arm as possible. It is recommend that if the tire carrier is mounted past the top of arm, that it go
no further than the 3 bottom slot locations. Spread out the mounting hole locations as much as
possible in conjunction with the arm.
√
X
HEIGHT EXAMPLE
HARDWARE MOUNTING LOCATION EXAMPLE
√ X

TIRE CARRIER PLACEMENT
-Attach the tire mount in the desired position and mount using the provided 1/2” hardware.
NOTE
Certain options may not work with all tire and wheel combinations or vary per vehicle
DO NOT mount the tire high or past the top of the arm
TIGHTEN ALL HARDWARE AFTER EVERYTHING IS INSTALLED ON THE VEHICLE.
CHECK AND RETIGHTEN ALL HARDWARE AFTER THE FIRST 100 MILES AND AFTER OFF ROADING.
CHECK REGULARLY