- 3 -
Getting Started
1. Remove all packaging including clear film around the tube. Please note,
the tube may contain a small amount of water, this is completely normal.
2. Place the Mini LED Bubble Tube on a flat solid surface.
3. Carefully fill the bubble tube with water from the top. If you spill any water,
please ensure this is cleaned immediately. Do not fill the tube to the top;
allow 2 inches (50mm) from the water level to the top of the tube.
4. Connect the DC connector from the low voltage transformer to the socket
in the base of the bubble tube.
5. Connect the low voltage transformer to a mains outlet.
6. The Bubble Tube will now illuminate and begin scrolling through many
colours.
Please note: Only use the transformer supplied. Use of a different
transformer may result in damage to the product and void the warranty.
For warranty information please see separate warranty card supplied.
Cleaning and Maintenance
The unit should be cleaned with a damp soft cloth. A non abrasive cleaning agent
may be used for stubborn stains. Ensure no liquid enters the base of the unit.
The unit has been designed for use by people with special needs, however this
does NOT mean it is unbreakable. You must ensure the unit is not hit with
anything and that no one pulls or pushes the unit.
Changing Bubble Tube Water
All bubble tubes require the water in them changed every 4 –6 weeks to slow the
build up of any bacteria.
1. Remove the lid off the column.
2. Carefully tip up the bubble tube and empty the water into a suitable
vessel.
3. Refer to the getting started section for filling instructions.
