Pull out the image completely.
Secure the roll with the locking key.
Mount the new image as in position 1.
Slow down the image with one hand when pulling out the locking key.
Let the image slowly roll into the system.
Take out the roll and remove the existing image by pulling off the roll and the top profile.
Replace the locking key underneath the system and
make a functioning test. (see item 3 last page).
Slow down the image with one hand when pulling out the locking key.
Let the image slowly roll into the system.
APreparing and mount the panel AChange the panel
Remove a small part of the protective liner on the fronttape.
Fix the panelstrip onto the image and adjust the image towards the strip.
Remove the remaining part of the protective liner. Press the image firmly onto the panelstrip.
Turn the image around and do the same thing with the security tape. (Not lockung version).
