expandastore
Assembly Instructions
General assembly instructions
• Read instructions thoroughly before commencing assembly
• For best results assemble on level, solid ground or it may affect alignment of the wall and ceiling panels
• On initial assembly, hand tighten all nuts and bolts then once full assembly has been completed,
tighten again with socket/spanner
• Keep all components and packaging if you plan to demount, move and reassemble in new location
The tools you will need
• 13mm spanner
• 19mm spanner
• Socket set including 13mm and 19mm sockets
• Screw driver
Safety notes
Please review all safety implications before commencing installation including suitability of desired location,
local hazards, access and personnel involved in assembly. If in any doubt refer to your company’s Health & Safety
officer or seek professional advice. Due care should be taken when lifting, assembling and demounting the unit.
General notes after assembly
• Once assembled, the unit can be lifted and re-positioned using a fork lift or crane
• For demounting and relocating in flat-pack condition, using the original packaging is recommended
Terms explained
• Capture nuts – This refers to nuts that are pre-attached to the component.
• Chassis – The main floor component
• Hand tighten – Tightened by hand so secure to hold in place but loose enough to allow for
small movement
• Demounted – When the unit is disassembled and returned to its original flat-packed state
