Page 5 03-67099 rev. 2017-04-06
Backstop for 1, 2 m x1, 8 m (4 x6 ft.)
EZgoal hockey goal
NOTE: Precision connection will t snuggly, use
rubber mallet or block of wood if needed.
Figure 1 Assemble 2 panels according to the
diagram. Note: the corner loops on each panel
should face each other and the down tube loops back.
Figure 2 Side panel assembly lacing
Secure the 4 corners of the net, so it is easy to
lace. Then labels should be on top. The lacing
should be snug. Start at the bottom in the middle
of the wiggle wire. Use the 4, 5 m (15 ft.) black
ropes. See details:
1) B Corners, lace every square box.
2) C Side and top, lace every other square box.
3) D Bottom, lace every square box. Tie off with
good knots.
Figure 3 Bolting the side panels
If you have an EZgoal hockey net, the holes are
predrilled to secure the side panels. Use (2) 80
mm bolts and the (2) buttery nuts on the top two
holes. Figure (E) and (I)
Figure 4 Backstop top net connection
The thick black rope and label must be on top.
(Detail F.) Using thin short rope corner ties, attach
the top net to the 4 corners steel loops. Secure the
heavy main rope on one panel to the steel loop,
pull tight and secure the main rope to the opposite
side panel. See (Detail G.) and the front of the color
box. Repeat for the bottom rope. Use the 1, 5 m (5
ft.) ropes to lace the top net to the side panels. See
(Detail G.) and Figure 4. Use the 38 mm ropes, tie
bow knots, to secure the top net to the goal in a few
locations (Detail H.)
Figure 2 Fasten tight every other square with the cordage
Figure 1
BCorner
lacing – lace
every square
box
CSide lacing
– lace every
other square
box
DBottom
lacing – lace
every square
box
38 mm (15 in.)
ropes goes here
Bolt
8 x 80 mm Bolt
8 x 30 mm
