EZ-ON 100SM User manual

100SM/100SNY
SEAT MOUNT/HIGH BACK SEAT MOUNT
IMPORTANT INFO
• Meets FMVSS213.
• Use Only with EZ-ON Vests Compatible Vest include: 103Z, 203PB, 303Z, 403PB.
• Use on school bus seats that have entry between the seat bottom and the seat back.
• Passengers seated behind occupants with Seat Mount must be wearing a seatbelt,
a transportation vest, or must be unoccupied.
• RegisterthisSeatMounttobenotiedofasafetyrecall.
EMERGENCY RELEASE PROCEDURE
When evacuating the passenger in a safety vest, the vest webbing is never cut. One cut of the portable
seat mount webbing below the buckle will allow the passenger to evacuate the bus wearing the safety vest.
100 SCBC
EZ-ON Safe Cut Belt Cutter
EMERGENCY CUTTING
EZ-ON PRODUCTS 1-800-323-6598
www.ezonpro.com
FOR SCHOOL BUS USE ONLY
WARNING
Death or serious injury can occur If manufacturer’s instructions are not followed correctly.
All EZ-ON products are dynamically tested to meet NHTSA standards. Please follow washing
instructions on product tag. Replace product if it is damaged, frayed, or has been in a crash.
Recommended replacement after six years.
EZ-ON Products are not liable for injury if these recommendations are not followed.
WARRANTY
EZ-ON Products stands behind the products we make. Warranty covers any defects in material or workmanships under
normal use during the warranty period. We will repair or replace product defects for 1 year from manufacturer date.

1-800-323-6598
www.ezonpro.com
INSTALLATION INSTRUCTIONS
1. Unlock seat and lift up.
2. Hang adjustable hooks from top of seat.
3. Securing mount strap:
a. Wrap mount strap around seat.
b. Connect push button. Face of push
button must be against bus seat back.
4. Tighten webbing:
a. Pull webbing snug. Mount strap must
be snug without slack in the webbing.
b. Webbing should be tight enought to
create a crease on the bus seat top.
5. Close seat. Allow sown non-adjustable
hook ends to extend 2 inches on seat.
6. Securely lock seat in place.
7. Properly seat passenger (hips low
against the back of the seat and
shoulders ush to the seat).
8. Attach the non-adjustable tether hooks
to the “D” rings located at the hip level
of the seated passenger’s vest. (
*Be sure that the passenger:
a. Has a properly tted vest
b. Has all closures secure
9. Attach adjustable hook ends to tether
slots on the shoulders and adjust the
hook ends to secure the passenger.
10. Tighten strap by pulling webbing
through the tilt lock adjuster.
123a
3b 4a 4b
567
8910
100SM/100SNY
SEAT MOUNT/HIGH BACK SEAT MOUNT
EZ-ON PRODUCTS 1-800-323-6598
www.ezonpro.com
FOR SCHOOL BUS USE ONLY