Pocket Rail Metal Support
Step 1 Top/Boom Pocket Rail Metal Support Installaon
Step 2 Connecng Pocket Rail into the Uprights Post
(4 Pieces Included)
Insert, all the way in, the Metal Pocket Rail support
into the Uprights Post. (Fig. 2 & 3)
Fig. 1
Pocket Rail
Uprights Post
USP © 2015
EZ Privacy Gate Kit Assembly Instructions
Pocket Rail
Metal Pocket
Rail Support
Uprights Post
Top Pocket Rail
Step 3 Insert the T&G Pickets in between the Top & Boom Pocket Rail (Fig. 4, 5)
Fig. 4
Fig. 3
Fig. 2
Uprights Post
Pocket Rail
T&G Pickets
IMPORTANT: Use a Square Level
Step 6 Secure Uprights Post and the Pocket Rail with 1½" Pan Head Sheet Metal Screws
Drive the Sheet Metal Screw into the
Upright Post in 3 spots (Fig. 9) then cover
the Pan Head Sheet Metal Screw head with
the Vinyl Screw Cap by tapping. (Fig. 10)
Repeat Step 6 on the remaining 3 corner of
the Uprights Post side.
Vinyl Screw Cap
(12 pcs included)
1½" Pan Head
Sheet Metal Screw
(12 pcs included)
Fig. 9
(4 Pieces Included)
Step 5 Top & Boom Uprights Post Metal Support Installaon
Uprights
Metal Support
Corner Lip
Corner Lip
Insert one Uprights Post Metal
Support into the Top Uprights Post
End Corner, make sure the corner
lip of the Uprights Post Metal
Support is facing towards the
Pocket Rail. (Fig. 8)
Using the ¾" Pan Head Metal Sheet Screw supplied, drive the
Fig. 9
USP © 2015
EZ Privacy Gate Kit Assembly Instructions
Fig. 6
Last T&G Must be Cut to Size
Tonque Groove
Last T&G Picket
Tonque Use this
side
Cut to Size
Groove
Step 4 Cut to Size the last T&G Picket
Fig. 8
Fig. 10
3"
¾"
Last T&G Picket
The cut side will be
the end side.
Pocket Rail
Upright Post
T&G Pickets
Upright Post
