Firstech, LLC. RF-2WG9R-SP Technical manual

8102REUCL000400 // REV1
QUICK START CARD
RF-2WG9R-SP
Tap the Lock Button to lock your doors and/or arm your vehicle. Hold this button for 3.5
seconds to activate panic/vehicle locater.
Tap the Unlock Button to unlock your doors and/or disarm your vehicle.
Hold this button for 2.5 seconds to pop your trunk. If not equipped, ask your Authorized
Dealer for details on how to get it.
Hold this button for 2.5 seconds to start your vehicle. Your remote’s LED will blink showing
the remote start run time. Repeat and your vehicle will shut off.
Auxiliary 1: Press and hold Trunk + Start Buttons for 2.5 seconds and then tap the Trunk
release button.
Auxiliary 2: Press and hold Trunk + Start Buttons for 2.5 seconds and then tap the Start
button.
Tap these two buttons at the same time to turn the horn or siren chirps on or off.
Tap these two buttons at the same time to turn Valet Mode off. Turn Ignition On and
tap buttons to turn on. Hold them for 2.5 seconds to turn your FT-DAS or Shock
Sensor on or off.
Tap these two buttons to activate Passive locking/arming. Your system will lock/arm
after 30 seconds if enabled. Hold these two buttons for 5 seconds to activate 2nd Car
Mode. Your LED will switch from amber to red. *Red LED denotes 2nd Car Mode.
2W4BLED_QuickCard.indd 1 2013/6/6 11:14:43

EVENT LEDS LED
DURATION
REMOTE
CHIRPS
Runtime Remaining: 100% Green Flash
Once Every
6 Seconds
6 Times
Runtime Remaining: 50% Amber Flash
N/ARuntime Remaining: 25% Red Flash
Runtime Remaining: 60 Sec. Red Flash
All Command Confirmations Green Flash 1 or 2 1 or 2
All Error Confirmations Green/Red Flash
3 Times 3 Times
Arming/Locking While Trigger
is Open Red Flash
PARKING LIGHT FLASHES REMOTE START ERROR
3 then 1 1: Motor running
3 then 2 2: Key in ignition on position
3 then 3 3: Door open
(manual transmission only)
3 then 4 4: Trunk open
3 then 5 5: Foot brake on
3 then 6 6: Hood open
3 then 7 7: Reservation off
(manual transmission only)
3 then 8 8: Tach or voltage sensing failure
3 then 9 9: FT-DAS sensor shutdown
3 then 10 10: System is in Valet Mode
START ERROR CODESLEDS
QUICK START CARD
Valet Mode: If your remote start is not working, you may be in Valet
Mode. Your parking lights will also not flash. Your doors will still
lock and unlock. To exit Valet Mode, tap the Lock and Trunk buttons
or turn the Ignition On and then tap the foot brake 10 times or
reprogram your remote(s).
To reprogram your remote first cycle the key in the ignition 5 times
within 7 seconds. Parking lights will flash. After that tap the Lock
button on your remote. Repeat for any additional remotes. If you
receive two parking light flashes, your system has exited remote
programming mode and you must retry.
Register online at www.compustar.com within 10 days of
purchase to activate your new remote’s warranty.
Questions/comments? Contact us at 888-820-3690 from 8
AM to 5 PM PST. Also please visit www.compustar.com for a
complete user’s manual.
2W4BLED_QuickCard.indd 2 2013/6/6 11:14:43
RF-2WG9R-SP