Firstech, LLC. RF-P1WG15R-FM Technical manual

8102REUCL000401// UM-FT-2W4B-LED REV1
Tap the Lock Button to lock your doors and/or arm your vehicle. Hold this button for 3.5
seconds to activate panic/vehicle locater.
Tap the Unlock Button to unlock your doors and/or disarm your vehicle.
Hold this button for 2.5 seconds to pop your trunk. If not equipped, ask your Authorized
Dealer for details on how to get it.
Hold this button for 2.5 seconds to start your vehicle. Your remote’s LEDs will blink showing
the remote start run time. Repeat and your vehicle will shut off.
Auxiliary 1: Press and hold Trunk + Start Buttons for 2.5 seconds and then tap the Trunk
release button.
Auxiliary 2: Press and hold Trunk + Start Buttons for 2.5 seconds and then tap the Start
button.
Tap these two buttons at the same time to turn the horn or siren chirps on or off.
Tap these two buttons at the same time to turn Valet Mode off. Turn Ignition On and
tap buttons to turn on. Hold them for 2.5 seconds to turn your FT-DAS or Shock
Sensor on or off.
Tap these two buttons to activate Timer Start Mode. Your system will start every 1.5 or
3 hours. Hold these two buttons for 2.5 seconds to activate 2nd Car Mode. Your LEDs
will switch from amber to red. *Red LEDs denote 2nd Car Mode.
Hold these two buttons for 2.5seconds turns the silent mode on or off. If on, the
Unlock and Trunk LED’s will change to red. Repeat to turn silent mode off. The LED’s
will change to green.
UM-FT-2W4B-LED _QuickCard 170913.indd 1 2017/9/13 19:37:21
QUICK START CARD
RF-P1WG15R-FM

ALARM TRIGGER EVENT LED FLASHES
Door, Hood, Trunk, or Ignition On triggered 2, Pause, Then Repeat
Full triggered shock sensor 3, Pause, Then Repeat
Optional sensor triggered 4, Pause, Then Repeat
Panic Mode 5, Pause, Then Repeat
PARKING LIGHT FLASHES REMOTE START ERROR
3 then 1 1: Motor running
3 then 2 2: Key in ignition on position
3 then 3 3: Door open
(manual transmission only)
3 then 4 4: Trunk open
3 then 5 5: Foot brake on
3 then 6 6: Hood open
3 then 7 7: Reservation off
(manual transmission only)
3 then 8 8: Tach or voltage sensing failure
3 then 9 9: FT-DAS sensor shutdown
3 then 10 10: System is in Valet Mode
ALARM LED CODES
START ERROR CODES
If you have an alarm and optional LED(s) installed, it will flash once
a second if armed. If your alarm is triggered then the LED(s) will flash
more than once until it is disarmed. See the table below for what
each LED code represents.
Valet Mode: If your remote start is not working, you may be in Valet
Mode. Your parking lights will also not flash. Your doors will still
lock and unlock. To exit Valet Mode, tap the Lock and Trunk buttons
or turn the Ignition On and then tap the foot brake 10 times or
reprogram your remote(s).
To reprogram your remote first cycle the key in the ignition 5 times
within 7 seconds. Parking lights will flash. After that tap the Lock
button on your remote. Repeat for any additional remotes. If you
receive two parking light flashes, your system has exited remote
programming mode and you must retry.
Register online at www.compustar.com within 10 days of
purchase to activate your new remote’s warranty.
Questions/comments? Contact us at 888-820-3690 from 8
AM to 5 PM PST. Also please visit www.compustar.com for a
complete user’s manual.
1W4B_QuickCard 130611.indd 2 2013/6/11 16:50:29
QUICK START CARD
RF-P1WG15R-FM