FirsTime & Co. Ava Mirrored User manual

INSTRUCTION
MANUAL
40248 Ava Mirrored
Jewelry Organizer

OVER THE DOOR HANGING INSTRUCTIONS:
1. Determine your preferred height for hanging and position hooks to
align with the corresponding hole.
2. Before screwing the hooks onto the back of the panel make sure
that the top of the hook is facing towards the door. (Fig D)
3. Screw in all 4 screws tightly to secure the hangers to the back of the
panel
4. Hang the panel over your chosen door
5. Determine desired location for Velcro strips
6. Place one side of the Velcro strip to the back of the panel and the
other side to the door to minimize movement of the panel on the door
WALL HANGING INSTRUCTIONS:
1. Place 1 EVA foam dot on each back corner of the panel
2. Determine your desired hanging location of the panel and mark
where screws should go
3. Place wall anchors into the wall at marked spots; make sure anchors
are level.To install anchor, use a phillips head screwdriver and screw
anchor into the wall. * Different wall materials may require a different type
of fastener. Use fasteners suitable for the walls in your home.*
4. Do not exceed 10 lbs in over all weight.
OVER THE DOOR HANGING INSTRUCTIONS:
1. Align storage compartment with the corresponding hole.
From the back, screw compartment onto front of the mirror panel. (Fig A)
2. Align hook bar with the corresponding hole.
From the back, screw small hook bar onto front of the mirror panel. (Fig B)
3. Align Bangle bar with the corresponding hole.
From the back, screw both U hooks onto front of the mirror panel. (Fig C)
Fig D. Hooks facing towards door
Fig A.Screw compartment bar to the front of the Panel
Fig B. Screw compartment bar to the front of the Panel
Place bangle bar
in U hooks
ASSEMBLY INSTRUCTIONS
Read these instructions carefully. Failure to follow these instructions can result in serious personal injury.
ASSEMBLY INSTRUCTIONS
Read these instructions carefully. Failure to follow these instructions can result in serious personal injury.
WALL HANGING
4 Screws for Door Hangers
2 Screws and compartment bar
DOOR HANGING
INCLUDES
2 Screws and Hook bar
INCLUDES
4 Screws, 2 U hooks and a Bangle bar
INCLUDES
2 Wall Anchors & Screws
Drill
Insert
place screw through
drill hole and tighten
into anchor
Fasten
Fig B. Screw hook bar to front of the Panel