Flexopower SK120 User manual

SK120_SK240_manual_foldable_en_V1.docx © Flexopower Desert Series. ll rights reserved.
1
Instructions Flexopower Foldable Kit
SK120 12W/SK240 240W
Carefully follow the instructions below for successfully operating the Flexopower SK120 /240 4x4 kit.
The Flexopower SK120 / SK240 Solar Camping kit are based on foldable, glass free, flexible solar panel
technology and includes everything needed to charge/manage the batteries from the sun: solar panel,
solar regulator with a remote LCD display, cabling, connectors and user manual. Easy to install, plug and
play principle. The SK120 / SK240 4x4 kit are suitable for marine, desert and tropical environments.
1. Caution
 Do not fold SK120 / SK240 solar panels other than in its default folding zones
 Do not stand on SK120 / SK240 solar panels when folded up
 Do not erect under or near power lines
 Do not stand on, walk or drive over SK120 / SK240 solar panels
 Do not tamper with cabling, equipment and connectors
 Do not pull on lead cables
 lways observe polarity: red/brown cable (+) positive; black/blue cable (-) negative
 lways use with a solar regulator with correct capacity
 The SK120 / SK240 kit as described here is suitable only for 12 DC systems. Please contact
Flexopower if you operate a 24, 36 or 48VDC system.
2. Complete kit consists of
Foldable
Panel
SK120 (120W)
SK240 (240W)
Foldable glass free solar panel with lead wire and
50 nderson grey connector
1x
2x
Solar regulator
1x
14 , 12V
1x
14 , 12V
LCD remote display [V, ]
No
No
Special ripcord twin core cable 4mm2
with 50
mp nderson grey connectors to connect panel
to regulator
1x 10m cable
2
x 10m
cable
User Manual
1x
1x
Please note based on client feedback, no battery cable is included.

SK120_SK240_manual_foldable_en_V1.docx © Flexopower Desert Series. ll rights reserved.
2
The power output of the Flexopower SK120 is suitable for smaller appliances and shorter stays in
camps without power. The power output of the Flexopower SK240 is suitable for 1-2 refrigerators and
longer stays in camps without power.
3. Assembly and disassembly (observe correct polarity: plus to plus, negative to negative)
3.1 Mount solar regulator with the remote LCD display in a suitable position as close as possible to
battery. Ensure solar regulator is protected from the elements, engine oil, engine heat etc.
3.2 Connect the solar regulator to the battery terminal at its battery symbol. Please note the
battery cable is not included in kit.
3.3 The solar regulator will now switch on.
3.4 Position SK120 / SK240 solar panel where it will have full day sun exposure. Temporarily leave
solar panel folded up until point 3.8. (eliminating the possibility of sparks when connecting the
solar panel to the solar regulator, i.e. no current flowing).
3.5 Connect SK120 / SK240 solar panel to the 10m cable via 50 mp nderson grey connectors.
3.6 Connect the 10m cable to the solar regulator via 50 mp nderson grey connectors.
3.7 The SK120 / SK240 ™ solar panel is now connected to the solar regulator and battery. Remove
Styrofoam and unfold the solar panel to full day sun exposure. The deep cycle battery is being
charged now.
3.8 Secure SK120 / SK240 through its eyelets if required.
3.9 The reverse order applies when disassembling. The solar regulator may be left permanently
connected to the battery terminals.
Optional
Permanently connect load (fridge, lights) to DC port of solar regulator. DC flows directly from
panel to load/consumer. Surplus DC power is stored in battery. ny balance will be supplied
from battery if DC output from panel is insufficient. utomatic switch during sun set and sun
rise.
Benefits:
 eliminate 15% waste/loss of generated solar power in battery
 reduced battery cycles and prolonged service life of battery
 measure consumption of load (fridge, lights) in mps via remote LCD display
Caution:
 do not connect load exceeding 14
 do not connect C inverter to DC port of solar regulator

SK120_SK240_manual_foldable_en_V1.docx © Flexopower Desert Series. ll rights reserved.
3
4. Maintenance, transport and storage
 Regularly wipe SK120 / SK240 solar panel with damp clean cloth
 It is recommended to transport and store the SK120 / SK240 solar panels in a vertical position
with the Styrofoam inserted
 Dry and wipe clean SK120 / SK240 solar panel for storage
 Refer to solar regulator and remote LCD display manufacturer’s instructions
5. Warranty
5.1 The SK120 / SK240 solar panels are covered by a 2year manufacturing defect warranty.
5.2 Refer to solar regulator and LCD display manufacturer’s warranty.
5.3 ll warranties and claims are null and void if the unit, connection and components have been
tampered with.
5.4 ll warranties and claims are null and void if the unit, connection and components have been
operated beyond their limitations.
5.5 ll warranties and claims are null and void in the event of reversed polarity.
5.6 ll warranties and claims are null and void if cautions under 1) have not adhered to.
6. Features SK120 / SK240 4x4 kit
 Foldable, flexible solar panel with eyelets on each side for proper securing
 Expansion ready to conveniently add additional solar panels if needed
Easy to set up. Plug and play principle
 More low light (overcast) and high temperature tolerant than glass solar panels
 Delivers up to 20% more energy into the battery than glass solar panels-virtually unbreakable
 Water, hail and dust proof
7. Specifications SK120 / SK240 Solar Panel Foldable Kit
IBS Order Number:
SK
120
SK
240
Flexopower Name
Mojave 120
™
Mojave 240
™
Pmax, Power
120W
240W
Imp,
Current at max. Power
6.1
12.2
Vmp, Voltage at max. Power
19.1V
19.1V
Weight of panel
3.2 kg
2x 3.2 kg
Dimensions deployed L x W x H each
155x56x1cm
2 x 155x56x1cm
Dimensions folded
up
L x W x H each
56x44x2cm
2 x 56x44x2cm
Solarcontroller
ECOterm14
ECOterm14
Specification Solarcontroller Current/Tension/Waterproof
14 /12V/IP68
14 /12V/IP68
Max. operating temperature
85°C
85°C

SK120_SK240_manual_foldable_en_V1.docx © Flexopower Desert Series. ll rights reserved.
4
8. Disclaimer
 Flexopower (Pty) Ltd and IBS GmbH shall not be held liable for any loss or damage suffered
from the use of this system.
 Flexopower (Pty) Ltd and IBS GmbH reserves the right to change the content of this manual
without prior notice.
SK120 /SK240
SK120 installed SK120 with integrated feet
Flexopower Energies (Pty) Ltd, Johannesburg, South Africa
IBS Inteligent Battery Systems GmbH, Seestrasse 24, CH-3600
Thun, Tel. [phone]
E-Mail: [e-mail] Internet: www.ibs-tech.ch