Flurida FDFM1JA01 User manual

1
w w w . f l u r i d a a p p l i a n c e s . c o m
https://www.fluridaappliances.com/product/countertop-nugget-ice-dispenser/
FDFM1JA01 Portable Nugget Ice Dispenser
Quickstart Guide
INSTALLATION REQUIREMENTS
Clearance Requirements
CAUTION
This unit is designed for countertop installation only.
Do not block the air vent on left side.
Allow for minimum 12 inches of clearance on the left side.
Allow for minimum 2 inches of clearance on the back.
Allow for minimum 1/2 inch of clearance on the top.
Electrical Requirements
DANGER
It is required that you connect this unit only to a GFCI protected
receptacle. It is strongly recommended that you do not use an adapter
or an extension cord to connect this unit because of potential safety
hazards.
A dedicated 120V, 60Hz, 15A fused, grounded electrical supply is
required. It is recommended that a separate circuit serving only your
appliance be provided.
Only connect to properly polarized outlets.
Use outlets that cannot be turned off by a switch.
Only plug the unit into a grounded 3 prong outlet.
USE OF DISPENSER
FIRST TIME USE
For the first time use flush the unit following instructions below.
For the first time use dispense several cups of ice and then discard
them.
Do not overfill the reservoir otherwise it may overflow when ice
melts completely.
1. Filling the water reservoir for the first time use
Remove the reservoir door by pulling its two sides outwards.
Add potable water to MAX WATER FILL.
Replace the magnetically attached door.

2
2
i n f o @ f l u r i d a a p p l i a n c e s . c o m
2. Flushing the unit for the first time use
Plug the unit into power.
Press and hold Clean button for 3 seconds to start the Cleaning mode for
flushing process.
Unplug the unit when the flushing process is complete (it takes 30
minutes and the Cleaning LED goes off).
Pull the drain tubes with plugs/holders out of the unit back and lower
them to a bucket or sink.
Remove the plugs/holders to release water.
Replace the plugs/holders and put the tubes with plugs/holders back to
the unit.
3. Making ice for the first time use
Add potable water to the MAX WATER FILL.
Plug the unit into power.
Press Make Nuggets button once to start making ice. The Making Ice LED
will flash slowly to indicate the unit is currently making ice.

3
24412 Main St. Suite 105, Carson, CA 90745
Filling the water reservoir when the Water Level red LED flashes
NOTE
Do not add water until Water Level red LED flashes.
Do not overfill the reservoir otherwise it may overflow when ice
melts completely.
Push the fill port door to open.
Add potable water until the Water Level green LED illuminates with 5
beeps.
Release the fill port door to close.
Or
Add potable water between MAX WATER FILL and MIN WATER FILL.