Flux Beambox User manual

Beambox Rotary Module Installation Guide
1. Installation
1.1 There are 4 items in the Rotary Module- the main body, T-handle, switch box and 2 pieces of stickers for
the switch box.

1.2 Remove the honeycomb platform by lifting out by tabs.
1.3 Place the main body into the machine. The black parts of the main body should be on
the right side.

1.4 Remove the first screw on the left side of the right cover and open it.
1.5 Thread both two cables of the switch box through the hole at the top of the partition.

1.6 Unplug the Y-motor cable in the circle from the mainboard.

1.7 There are 2 cables of the switch box. One is plug and the other is receptacle.
1.8 Please insert the plug cable of switch box to the mainboard where you just unplugged.

1.9 Connect Y-motor cable you unplugged from the mainboard to the receptacle cable of
the switch box.

1.10 Two cables from the switch box should be connected like the picture below.

1.11 Put on the stickers on the switch box and attach it to the side.

1.12 Insert the black cable of the main body to the switch box.
Please keep switch in the off position until prompted to switch it on.

1.13 Install the T-handle into the right side of the main body.
1.14 Make sure that the rotary function switch is in the off position. Having it on before
being prompted gives confusing error codes.