Congratulations!
FountainLine would like to congratulate you on your
decision to purchase Australia’s most recognised and
trusted brand of sports field line marker. We trust
that you will be completely satisfied with your new
ProLine V4 and its advanced design features, making
it the most versatile, reliable and easiest line marker
you will ever use!
Unpacking and Setting Up
1. Loosen off handle locking screws and slide handle
into vertical handle support tubes, set to desired
height and lock screws into position.
2. Remove from tank the marking disc assembly
and slide into position on the front of the marker,
locking the screw in the desired position.
3. Using the allen key provided with the marker,
set the marking discs to the appropriate width
and lock screws with key.
4. Fit the nozzle assembly onto the spigot on the
marking disc frame and lock screw. Set nozzle to
correct height to achieve the desired line width.
5. Lift the front cover and pass the spiral hose
through the hole. Insert the end of the hose into the
elbow located at the top of the nozzle assembly.
6. Ensure the battery is completely charged
by plugging in the charger located in the
battery compartment.
Directions For Use
1. Check the FastClean™ valve is turned to ‘Spray’.
2. Lift out the tank filter and pour in the required
amount of water followed by the required amount
of paint. Stir thoroughly ensuring all paint and water
is mixed. Ensure a minimum of 15 litres is mixed
for first use as this is required for initial priming
of the pump.
3. Place tank filter back into container and secure
the lid.
4. Switch the line marker on for approximately
45 seconds to allow the paint solution to pump
through the entire delivery system (for first use
and after dry running).
5. After line marking is completed, clean the delivery
system by plugging a standard garden hose into the
quick connect fitting of the FastClean™ system and
turn handle on the FastClean™ valve to ‘Flush’.
6. Turn on hose and switch on the pump until
clean water is spraying out of the nozzle
(approx. 1-2 minutes).
7. Turn off the pump and disconnect garden hose.
Pack away for next use.
IMPORTANT NOTE: Please ensure the FastClean™ lever
is left on ‘Flush’ after cleaning to avoid paint entering
the discharge system, causing possible damage to
the pump.
Recommendations
1. The battery is a deep cycle battery and needs to be
charging at all times when not in use.
2. Clean paint tank out if line marking not required for
more than 1 week.
3. Use genuine FountainLine marking liquids — this will
prolong the life of the line marker and maintain your
10 year warranty.
4. Always use FountainLine spare parts to maintain
warranty.
5. Remove FastClean™ filter and rinse with hot
water monthly.
6. Clean the nozzle with a soft bristle tooth brush
when required. DO NOT use metal or sharp objects.
Your New FountainLine ProLine V4 Line Marker
