Fraser Hill Farm Let It Snow FSSM029A-BLU User manual

1
List of parts
Schematic
Caution
•This product is fragile and should be assembled with care.
•The product is for indoor use only and is not suitable for outdoor or any location with drafts.
•Please follow the below steps and requirements specified in the instruction to ensure safety and reliability during the
installation.
•Use caution with children under the age of 8. Children should keep a safe distance to avoid inhaling snow particles and possible
suffocation.
No.
Description
Quantity
1
Transformer
1 unit
2
Umbrella-shaped base
1 set
3
Ring support
1 pc
4
Figures
1 set（3 pcs）
5
Christmas tree
2 trees
6
Light String
1 string(2 tips)
7
Street lamp (Combined type)
1 set
8
Wreath
1 pc
9
Snow flakes
1 bag
10
Top
1 pc

2
1) Install Street Lamp
•Unfold the umbrella-shaped base.
•Assemble the street lamp components as shown on schematic and insert the
plug at bottom into No. 1 jack in the base.
•Note: Tighten up each screw so that the lamp tube forms a strong base for
the product.
2) Fit ring support and its fittings
•Assemble the corresponding numbered ring support with its fittings as
illustrated.
•Put the ring support on umbrella support in the direction as indicated by
•Mount the figures and Christmas trees one by one onto the ring support as
illustrated.
3) Arrange the trees and fit the light string
•Unfold branches of two trees to get the desired shape. Insert the plug of light
string into the No. 2 jack in the base and decorate the string tips on the trees
respectively.
4) Testing the Snowflakes
•Confirm all the above instructions have been completed.
•Make sure there is no blockage in the snow container so there is a flow of
snowflakes.
•Set the switch at OFF and connect the transformer into the power source.
•Put a small amount of snow flakes at the bottom of the snow container, and
turn on the switch. Check if flakes are spouting out from the top of the street
lamp. Music and lamps should be properly functioning. If there are any
issues, check the contact of wiring and try it again until all functions are
resolved.
5) Pour in the flakes
•Turn off the switch. Evenly distribute the snowflakes into the umbrella shaped
base. It is suggested to keep an appropriate amount of snowflakes aside, for
when some fall out.
6) Completion of assembling
•Fit the wreath.
•Turn on the switch; you will see snow flakes spouting from the top, the light
string flashing and music starting. Now all assembly has been completed.
7) Adjust and enjoy
•Adjust the wind switch to get appropriate wind for best snow falling effect,
and also avoid flakes flying out of the container.
•Music can be controlled by the switch and can be turned off when not
needed:
I —Music turned off and other functions are normal
II—Music turned on and all functions are normal.
Assembly Instructions