WHAT TO DO...
When the fridge is not in use for a prolonged period:
• Remove thepowerplug from the power point.
• Remove all contents from the fridge.
• Drythe interior and leave thedoor open for a few days.
When you wish to move the fridge:
• Secure all movable parts and contents.
(Package them separately if necessary.)
• Transport the fridge only in an upright position. In any other position you
may damage the compressor.
Beforecalling service,pleasefollowthe checklist below.
This may save you an expensive service call.
WARNING-Improperuseofthegroundingplugcanresultina riskofelectric
shock. Ifitisnecessarytouse anextensioncord, use onlya3-wire extension
cordthat hasa3-bladegroundingplug anda3-slotreceptaclethat will
acceptthe plugonthe appliance. The markedrating of the extension cord
shouldbeAC115-120V,10A,ormore.Ifa groundingadapter isused,make
surethe receptacle box isfully grounded.
If the refrigeratorseemstoo warm inside:
• Check that the door has not been opened too frequently or fortoo long.
• Check that the interior circulation isnot obstructed by having too many
goodsstored. (The fridge is overloaded)
• Did you store anything hot.without firstcooling it to room temperature?
• Is there sufficient clearance around all sidesand above the fridge?
If the fridge starts making any unusual noises:
• Is it wobbling? Re-level itand check if it now operates normally.
•Have any objects fallen behind the fridge? If so,remove them and check if
operation is nownormal.
• Are any containers inside the fridge vibrating or resonating? If so, rearrange
them then check to see if operation has returned to normal.
7. Insert thebottom hinge atthe left side
usingthe twoscrewspreviously removed
in step6.
NOTE: Do not tighten screws.
8.Standthe cabinet.
9.Replacethe doormakingsurethebottom
socketentersthe bottom hinge pin.
Be surewashers areinplace.
10.Whileholding thedoorintheclosed
position,securethetop hinge attheleft
side using thetwo screwspreviously
removedatthe beginninginstep2.
Donottightenthescrewsuntilthetopof
thedoorisleveledwith thetopcabinet.
11.Replace thehingecover.
12. Tools required:
-8MM& 10MMsocket-ratchet.
-Putty knife or thin-bladescrewdriver.