Frigidaire FFFU20F4V User manual

Started
WITH YOUR
FRIGIDAIRE UPRIGHT 20 CU FT FREEZER
GETTING
Set your freezer temperature
It’s easy! When first turning your appliance on, adjust to Recommended. Some
models have a power indicator light projected on the floor. To ensure safe food
storage, allow the appliance to operate with the door closed for at least 8 hours
before loading it with food. If necessary, we recommend you adjust the temperature
gradually, in small increments, allowing the temperature to stabilize.
YOU’RE IN CONTROL
1. Adjusting the appliance temperature control
to OFF turns o the compressor and prevents
the appliance from cooling but does not
disconnect the power to the light bulb and
other electrical components. To turn o
power to your appliance, you must unplug the
power cord from the wall outlet.
2. For warmer temperatures, adjust the setting
to Cold. For colder temperatures, adjust the
2
3
1
3
2
4
5
6
setting to Coldest.
3. The control can be left at the factory preset
(Recommended) or adjusted as desired.
4. If the temperature inside the cabinet increases, the red High Temp* light will
illuminate and the alarm will sound.
5. The Freeze Boost* mode quickly drives the appliance to a colder temperature
and stays active for up to 24 hours before automatically deactivating or being
manually exited.
6. Pressing the Temp* button will allow you to scroll through the five temperature
settings from Cold (top) to Coldest (bottom), and then loop back to Cold.
*Refer to your Use & Care Guide for detailed information.
BEFORE YOU START
Set up your freezer
Prior to using the freezer, make sure it is located on a floor that is level and strong
enough to support it fully loaded. Check out INSTALLATION in your Use & Care
Guide to see how to set the anti-tip bracket.
Before operating for the first time
Clean the inside of your appliance before using it. See the CARE AND CLEANING
section in your Use & Care Guide.
A17275603 (1910)

Take the first step to becoming a part of the Frigidaire family by registering
your upright freezer.
Look for the PhotoregisterSM icon on your registration card.
LET’S MAKE IT OFFICIAL!
PHOTOREGISTER
SM
QUICK CARE
A little love goes a long way
Wipe up any spills immediately and clean the freezer and
appliance compartments at least twice a year.
Easy-to-Clean, Smooth Exterior
Our smooth exterior finish wipes down more easily than
traditional textured finishes.
FAQs
What does the alarm or “buzzer sound” mean?
If the temperature inside the cabinet gets warmer, the High Temp alert will sound. It’s
best to make sure your freezer is on a level surface, and the door closes freely and with a
proper seal. Once you close the freezer door, leave it closed so the freezer temperature can
decrease. If this does not correct the issue, check your Use & Care Guide for information on
how to reset the alarm.
The freezer temperature is warmer than preferred. What’s wrong?
If the freezer temperature is warmer than you’d like, adjust the control to a colder setting until
the freezer temperature is satisfactory. Allow 24 hours for the temperature to stabilize.
Why does my freezer make noise or vibrate?
If your freezer is vibrating or rattling, check the below:
1. Install the appliance on a floor that is level and strong enough to support a fully
loaded appliance. Adjust the anti-tip bracket. See “Setting the anti-tip bracket” in
the INSTALLATION section of your Use & Care Guide.
2. Check to see if the freezer is touching the wall. If so, move it slightly.
3. Remove any items that are on top of the freezer.
4. Check items inside the freezer. It is normal for items inside the freezer to vibrate
somewhat. If it seems they’re vibrating too much, try moving the freezer slightly.
Find more troubleshooting tips in the back of your Use & Care Guide.
here
FOR YOU
WE ARE
Want help?
Have a question? Need service?
frigidaire.com/1 [phone]
frigidaire.ca/1 [phone]
owner support