Fujitsu FJ-RC-WIFI-1NA User manual

Wi-Fi Wired Device
FJ-RC-WIFI-1NA
Quick Installation Guide
Contractorinstallation
FJ-RC-WIFI-1NA
WARNING:
• Refer to this Quick Installation Guide to install Fujitsu Wi-Fi Wireless Device IS-IR-WIFI-1 only. This guide does NOT replace
any installation manual(s).
• Make sure the work is done by a license qualify contractor
• Have contractors refer to the installation manuals that accompany this unit for complete and specific installation details and
requirements.
• The manufacturer shall in no way be responsible for improper installation, start-up, maintenance or service, including issues
caused by failure to follow all appropriate instructions in the installation manuals.
• Carefully read the installation and owner manual(s) before beginning.
•NOTE to Contractors: For technical support, contact your Fujitsu Distributor.
Compatibility& Requirement
Recommended for the following indoor types:
Slim Duct / Cassette / Ceiling / Universal type
• Device does not include connecting wire.
• Please use Thermostat wire .

FJ-RC-WIFI-1NA
F
1) UTY‐WIFIplugandWi‐Fideviceisnecessary.Refertocompatibilitychartformoreinformation.
2) UTY‐WIFIplug,InterfaceBoardandWi‐Fideviceisnecessary.Refertocompatibilitychartformore
information.
FJ‐RC‐WIFI‐1NA
ASU12RLFIndoorBoard
UTY‐WIFI
FJ‐RC‐WIFI‐1NA
InterfaceBoard
1)
2)
InstallationExampleForWallMountedTypeIndoorunits
ConnectingWi‐Fidevice(FJ‐RC‐WIFI‐1NA)todifferentsizeindoorunits(ASU’s)
ASU18RLBIndoorBoard
UTY‐WIFI
UTY‐WIFI
FieldSupplied
FieldSupplied
ConnectingWire
RED
BLACK
RED
BLACK
1
2
3
1
2
3
WiredDeviceInstallation
Note*:ThisisaMasterorSlaverelationship.SettheFujitsuRCorIntesisdevicetoeitherMasterorSlave.DoNOT setbothto
thesamemode.
(SLAVE)
(MASTER)
5

SettingupWireless Device
Beforestarting
AB
Youneedthefollowing:
•IntesisHomeDevice
•Wi‐FiDevice(laptop/smartphone/tablet)
•AccessPointorRouter
•QuickStartGuide/Installmanual
FJ-RC-WIFI-1NA
7FtMax
Getclosetothedevice
OK
CheckWi‐FiSignalstrengthonthe
placementlocation.
• If you don’t have enough Wi-Fi signal:
a. Try to install the IntesisHome device in another place
b. Move the router closer to Wi-Fi module.
• If you have enough Wi-Fi signal then proceed to install.
AB
•Gotoyourdevicenetworksettings.ClickontheINTESISHOMEinsideyournetworkoptions.
2)OpenWebbrowser
Settingup
2
WithyourSmartphone,Tablet
orLaptop,searchfortheWi‐Fi
networkcalled"INTESISHOME"
andconnecttoit.
Onthesamedevice.openaweb
browserofyourchoice.
1)SelectIntesisHomeDevicenetwork
1

Settingup
3
4
Settingup
5
SelectyourWi‐Fi
network
6
ClickNext
Insert
Password
Goto ihconfig.com

Settingup
Devicewillblinkinthefollowingsequence:
*Note:IftheWi‐Fideviceisnot connectingtoyourWi‐Finetwork.Pleasere‐checkthefollowing
andstartfromstepone.
•Check Wi-Fi Signal Strength
•Check if internet service is active (Connect to Wi-Fi network with smart phone to verify the internet connection isworking)
•Make sure you are selecting the right network.
•Make sure you are entering your network password properly (Case sensitive)
Pressandholdfor
10secondsand
releasetheback
buttononthe
device.
AfterVerifyingthesepoints:
1) 2)
LEDturnssolidgreen
3)GobacktoStepnumberOneand
startagain
7Done!
https://user.intesishome.com/login
8Fillformtocreateaccount.
Click
Newuser:Thepictureabove
willautomaticallyasktoadda
device.
Note*ConfirmtheIntesisHomeEmailbeforemovingtostep8b.
Registrationnumberislocatedinthe
backofthephysicalWi‐Fidevice,Boxor
manual.
Oncethedeviceisregister.Youare
nowreadytocontrolyoursystem.
DownloadIntesisHome
applicationfrom:
8c
IOS Android
Signinwithyournew
accountandenjoy
controllingyourFujitsu
system!
Registering
Gotowebsite
https://user.intesishome.com/login
8b
8a

SensingAmbient(Room)Temperature
•Ambienttemperaturecanbeobtainedfromtwodifferentlocations.
DefaultSetting
UsingtheFujitsuRemoteControllertocontrolandreporttemperature
Temperature sensor
reports readings to
application
The Fujitsu wired remote controller can be use to
control the system base on ambient temperature of the
controller.
Benefits:
•Intesis device can be install away from plain sight
without affecting ambient temperature reading inthe
application.
•Application can show the control temperature.
Caution:
•Fujitsu wired remote controller shall be install inside
living space
Please follow the steps below to activate sensor of
Fujitsu wired remote controller. Refer to 9b-1 and 9b-2.
Indoorunitreturn
airthermistor
ActivatingTheThermoSensor
Press the “ECONOMY/ THERMO SENSOR” button on the Fujitsuwired
remote controller for 5 seconds or more.
To select the temperature sensor of the indoor unit or the remote controller.
After 5 seconds a picture of the thermos sensor will appear on the screen.
ThermoSensorActivated
RoomTemperatureControlSwitching
To control the Fujitsu system by the thermo sensor in the Fujitsu Wired
remote controller. Function setting 42-01 and 48-01 must be set. Please refer
to the wired remote installation manual for more details.
Example
If 9b-1 and 9b-2 are not set, ambient temperature on the application is
sensed at the Intesis device. The indoor unit’s return air thermistor
controls the Fujitsu system according to set temperature.
By default, the Intesis device reports ambient
temperature to the IntesisHome App.
The indoor unit’s return temperature sensor controls the
system base on its return temperature.
Caution:
•Intesis device shall be install inside living space.
•The ambient temperature shown in the application is
not a control temperature of the unit. The controlling
temperature is located in the return of the indoor unit.
Control
Temperature
Ambient
Temperature
NOTE*ControlTemperatureshouldbeclosetotheset
pointtemperature.Howevertheymayvarydependingon
indoorairthermistor,RClocation,roomsizeandorair
filtration.
74F*
Indoorunit
Indoorunitreturn
airthermistor
9a
9b
9b‐1
Indoorunit
9b‐2
Indoorunit
79F
9

MultipleindoorunitApplication:StepstoRegisterNew(additional)
Devices
1)InyourIntesisHomeaccountclickonthesettingsoption
Click
2)ClickonDevices Click
3)ClickonAddaFacility.Fillallinformationneeded thenClickonthe
plussign(+)
4)Fillandverifycode.Codeislocatedonthe
deviceorintheproductsbox.Followthesame
procedureifyouhavemorethanonemodulein
yourinstallation.
Click
Click
Multipleindoorunit(includingMulti‐Zone)Applications
BranchBox
BranchBox
BranchBox
48HFI
•EachindoorunitmusthaveitsownIntesisWi‐Fi
moduletomanageeachzoneindependentlyinone
account.
X:DonotinstallWiredWi‐Fi
moduleontotheBranchbox
Centralremotecontroller
terminalblock
•Room1
•Room2
•Room3
•Room4
Room2
Room3 Room4
Room1
X

Warning
Alwaysusealicensed,qualifiedinstallerorcontractorto
installthewiredmodule.Donottrytoinstalltheproduct
yourself.Improperinstallationcanresultinelectricalshock,
fireorexplosion.Useonlyparts,accessoriesandcontrols
suppliedorspecifiedbyFujitsu.Askalicensedcontractorto
installallparts,accessoriesandcontrols.Useof
unauthorizedorimproperinstallationofparts,accessories
andcontrolscanresultininjury,majorequipmentrepairsor
propertydamage.Readtheowner'soperationmanual
carefullybeforeusingthisproduct.Theowner’soperation
manualprovidesimportantsafetyinstructionsandwarnings
whichshouldbefollowedclosely.Foranyquestionsor
concerns,pleasecontactFujitsuGeneralAmerica,Inc.
Non‐InternetRetailPolicy
Internetsalesarestrictlyprohibitedandunauthorized.Any
FujitsuHVACsystemsorcomponentspurchasedonthe
Internet,fromanonlineretaileroranysimilare‐tailing
website,ORwheretheoriginalfactoryserialnumbersofthe
displayhavebeenremoved,defaced,orreplacedinanyway
WILLNOTBECOVEREDBYWARRANTY.
Trademarks
TheFujitsulogoisaregisteredtrademarkofFujitsuLimited.
TheHalcyonlogoandnameisatrademarkofFujitsuGeneral
America,Inc.
Copyright©2015FujitsuGeneralAmerica,Inc.
Fujitsu’sproductsaresubjecttocontinuousimprovements.
Fujitsureservestherighttomodifyproductdesign,
specificationsandinformationinthisbrochurewithout
noticeandwithoutincurringanyobligations.
FujitsuGeneralAmerica,Inc.
353Route46West
Fairfield,NJ07004
TollFree:(888)888‐3424
Local:(973)575‐0380
Fax:(973)836‐0447
Email:[e-mail]
www.fujitsugeneral.com
Asubsidiaryof
FujitsuGeneralLimited
Rev.3/16
FAQ’s Latest Sell
Sheet
ErrorCodeDefinition