GAS AirOzone 150 User manual

NEVER CONNECT TO THE MAINS
UNLESS INSTALLED IN SEALED DUCT
WORK WITH AIR FLOWING TO THE OUTSIDE!
USER MANUAL

The AirO
3zone uses ozone
to completely remove
odours from polluted air.
When using the AirO
3zone,
safety precautions need
to be observed. Therefore
please read these
instructions very carefully.
Safety instructions
The AirO
3zone is exclusively for
industrial use.
Warning electric shock
The AirO
3zone generator
makes use of high voltages.
Do NOT touch conducting
(metal) parts, inside the
body of the AirO
3zone when
connected to the mains (230V)
Warning harmful GAS
Never turn on the AirO
3zone
unless it is correctly sealed into
duct work, and air is flowing.
Ozone is very harmful in high
concentrations.
Installation instructions
AirO
3zone should be installed in a ventilation duct after your fan and filter. At least
five metres of ducting should be used after the AirO
3zone, this is to let the ozone have
sufficient time to react with the odours in the air.
The Ozone and air must be ducted outside.
The air from the duct cannot go to a closed area because of the high concentration
of ozone. The ozone from the AirO
3zone will react with odours in the air. All odours
will be destroyed. It is possible that more ozone is produced than necessary to remove
all the odours.
Diameter (mm) 15 0 200 250 315
Ozone plates 1235
Max Air Capacity (m3/h) 600 1200 1800 3000
Max power (w) 10 20 30 50
Ambient temperatures °C -20°C + 50°C
Max Humidity 80%*
*Ozone production reduces with high humidity.
Fully Serviceable
AirO
3zone is a quality product made in the EU, however over time the corona
discharge plates oxidise. Global Air Supplies can replace the plates. Contact us for
more information. [email protected]
Technical Data
CAUTION
CAUTION