95mm
3 3/4"
495mm
19 1/2"
630mm
24 3/4"
40mm
1 5/8"
600mm
26"
95mm
3 3/4"
495mm
19 1/2"
630mm
24 3/4"
660mm
26"
40mm
1 5/8"
448mm
17 5/8"
225mm
8 7/8"
380mm
15"
INTERNAL
EQUIPMENT
SPACE
IMPORTANT NOTE
Apply brakes at all times
(Unless AV/VC One
is being moved)
IMPORTANT NOTE
Remember to support the back
panel when unlocking to prevent
it falling.
Some important precautions
95mm
3 3/4"
495mm
19 1/2"
630mm
24 3/4"
40mm
1 5/8"
600mm
26"
95mm
3 3/4"
495mm
19 1/2"
630mm
24 3/4"
660mm
26"
40mm
1 5/8"
448mm
17 5/8"
225mm
8 7/8"
380mm
15"
95mm
3 3/4"
495mm
19 1/2"
630mm
24 3/4"
40mm
1 5/8"
600mm
26"
95mm
3 3/4"
495mm
19 1/2"
630mm
24 3/4"
660mm
26"
40mm
1 5/8"
448mm
17 5/8"
225mm
8 7/8"
380mm
15"
WARNING
• Do not install screens/displays heavier than 60kg/132lb. Total weight of installed
equipment must not exceed 120kg/264lb, symmetrically distributed.
• Use with products heavier than the maximum weights indicated may result
in instability causing possible injury.
• Correct installation is essential to safe and reliable operation of the
AV/VC One product and falls outside the scope of responsibility
of Colebrook Bosson Saunders. Please follow assembly instructions carefully.
• Do not use this product for any purpose other than that for which it was designed.
• Ensure that oor or wall surface is strong enough to support the weight of the
fully-loaded AV/VC One and that the oor surface is at and level.
• Do not install AV/VC One outdoors or in environments where it will be
directly exposed to moisture or high winds.
• Follow the manufacturer’s guidance for mounting of screens, displays and
other equipment.
• Please take care to avoid trapping ngers when installing or adjusting the product.
IMPORTANT
• Maximum screen size to be mounted:
• Single screen installation: 80” max size. 60kg (132lbs) max weight.
• Dual screen installation: 65” max size. 60kg (132lbs) max weight.
• It is recommended that screens are removed before moving the AV/VC One unit.
ELECTRICAL SAFETY
• Safe installation of electrical equipment is the responsibility of the installer.
• Colebrook Bosson Saunders recommends that only double-insulated
electrical equipment and cables are installed in AV/VC One unit.
MAINTENANCE AND INSPECTION
• Ensure all screws and xings are fully tightened and occasionally re-tighten if necessary.
• Clean with a dampcloth. DO NOT use solvents.
DISCLAIMER
As part of ongoing product improvement programme, the design of
products may change without prior notice and details may vary from
those illustrated.
