05 English
AirPlay：Please go to Apple’s official website http://www.apple.com/airplay for more information.
DLNA： Please go to http://en.wikipedia.org/wiki/DLNA for more information.
Bluetooth Mode:
Press Power/Mode button - the MODE LED will flash white and Bluetooth Mode is now on.
In your device settings, turn Bluetooth ON. Connect to ‘GGMM_M3’ open your music player
and press play. (iPhone as example)
AUX Mode:
Press Power/Mode button - the MODE LED will turn solid green, and it is now in AUX Mode.
Connect your device to the speaker with the AUX cable, open your player and play your music.
Multi-room Play in Wi-Fi mode
Please Note: “GGMM MUSIC” app is required to set up.
Multiple M3 units can be connected in Wi-Fi mode; you can also set up
multiple M3 in different rooms to play the same music.
Setting up M3 L/R channels in Wi-Fi mode
Please Note: “GGMM MUSIC” app is required for set up.
Please Note: For more information about the M3, please visit our website at www.ggmm.com
When you use two M3 units in Wi-Fi mode, you can set up the M3 as
individual‘L’ (left) channel and ‘R’ (right) channel to get wider range of
the stereo effect.
Left
Listening
Position
0°
-30° +30°
Right
Wi-Fi is a registered trademark of the Wi-Fi Alliance.
Bluetooth is a registered trademark of the Bluetooth SIG, Inc.
Airplay is a registered trademark of Apple Inc.
FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
o Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and receiver.
o Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
o Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your
authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
To comply with FCC RF exposure compliance requirements,this grant isapplicable to only mobile
configurations. The antennas used for this transmittermust be installed to provide a separation
distance of at least 20 cm from allpersons and must not be co-located or operating in conjunction with any
otherantenna or transmitter.
