GIGA-BYTE TECHNOLOGY i1320 Installation instructions
技嘉科技股份有限公司
GIGA-BYTE TECHNOLOGY CO,LTD
BAREBONE
組裝作業指導書
Standard Disassembly Procedure
Application: Disassembly Line
Customer:
Model: i1320
Scope:
Version: 1.0
Release date: 2009-11-09
BOM P/N: 9WI1320＊
編寫: Julia Huang 單位主管: 部門主管:
(Editor) (Parts Chief) (Manager)
No Status Tooling Description Notice Remark
1 N/A N/A N/A N/A N/A
Document History
Item Revision Description Date Originator
1 1.0 WI 初版 2009/11/09 Julia Huang
No Status Tooling Description Notice Remark
2 Remove KB Screw Driver Remove KB Be caution when
remove As illustrated
1.Remove KB.
[ 1-1 ] Remove Battery、Rubber Foot and Cover Docking.
[ 1-2 ] Remove KB.
No Status Tooling Description Notice Remark
3 Remove Key
Parts Screw Driver Remove Key Parts Be caution when
remove As illustrated
2. Remove Key Parts.
[ 2-1 ] Remove 4 screws, Remove Doors.
[ 2-2 ] Remove the memory chip from the memory slot Take out the RAM module from the connector.
No Status Tooling Description Notice Remark
4 Remove Key
Parts Screw Driver Remove Key Parts Be caution when
remove As illustrated
[ 2-3 ] remove 1 screw and two cables then take out WIFI+WIMAX card.
[ 2-4 ] remove 2 screws and two cables then take out 3.5G card.
灰-Gray、黑-Black
[ 2-5 ] remove 1 screw then take out 3.5G card.
No Status Tooling Description Notice Remark
5 Remove MB Screw Driver Remove MB Be caution when
remove As illustrated
3. Remove MB.
[ 3-1 ] Remover 14 screws.
[ 3-2 ] Remove Touch button cable and Touch Pad cable.
No Status Tooling Description Notice Remark
6 Remove MB Screw Driver Remove MB Be caution when
remove As illustrated
[ 3-3 ] Disconnect BT Module
[ 3-4 ] Remove Cables and 6 screws.
No Status Tooling Description Notice Remark
7 Remove MB Screw Driver Remove MB Be caution when
remove As illustrated
[ 3-5 ] Remove 2 screws.
[ 3-6 ] Remove 4 screws and disconnect the cable.
No Status Tooling Description Notice Remark
8 Remove LCD Screw Driver Remove LCD Be caution when
remove As illustrated
4. Remove LCD.
[ 4-1 ] Remove 4 screws.
[ 4-2 ] Remove Rubbers and 4 screws, then remove LCD Bezel
No Status Tooling Description Notice Remark
9 Remove LCD Screw Driver Remove LCD Be caution when
remove As illustrated
[ 4-3 ] Remove Hinge Cap.
[ 4-4 ] Remove 4 screws.
[ 4-5 ] Remove LCD cable.
No Status Tooling Description Notice Remark
10 Remove LCD Screw Driver Remove LCD Be caution when
remove As illustrated
[ 4-6 ] Remove Web camera Cable then remove Web camera module.
[ 4-7 ] Remove 4 screws.
No Status Tooling Description Notice Remark
11 Remove Touch
Button Screw Driver Remove Touch Button Be caution when
remove As illustrated
5. Remove Touch Button.
[ 5-1 ] Remove 2 screws.
[ 5-2 ] Remove the cable.
Table of contents
