GitUp G3 Guide

ZEB Cam for Revo - GitUp G3 Camera Reset
Overview
In this article you can find all the steps required to reset your ZEB-CAM - GitUp.
Note: Please check your camera model first to make sure you are following the correct procedure.
Procedure
If you're not sure which ZEB Cam version you have, check out this article first: Which ZEB Cam version do I have?
1. Remove the camera retaining screw using a 4mm hex key.
https://knowledge.faro.com/Hardware/GeoSlam/ZEB_Revo_and_Revo_RT/ZEB_Cam_for_Revo_-_GitUp_G3_Camera_Reset
Updated: Wed, 11 Oct 2023 20:02:38 GMT
1

2. Remove the camera from the frame.
3. Remove the SD card from the camera.
4. Power on the camera by pressing the Power/Mode button on the front of the camera.
5. Ensure the camera is set to video mode. Short press the Power/Mode button on the front of the camera to cycle
between Video mode, Camera mode and Pre-view mode.
6. Enter the Camera settings by touching the Camera Settings icon on the touch screen.
https://knowledge.faro.com/Hardware/GeoSlam/ZEB_Revo_and_Revo_RT/ZEB_Cam_for_Revo_-_GitUp_G3_Camera_Reset
Updated: Wed, 11 Oct 2023 20:02:38 GMT
2

7. Swipe left to page 4 of the camera settings.
8. Select the Reset Option to reset the camera to default settings.
9. Make the following camera settings:
Camera settings
System Settings Page Changes to Default
Car DVR 1 ON
Ext power 2 CHARGE
USB 2 MASS STORAGE
Lock 3 OFF
Auto Off 3 3 minutes
Set Time 4 Current date/time
10. Swipe down to exit the Camera settings.
11. Enter the Video Settings by touching the Video Settings icon on the touch screen.
https://knowledge.faro.com/Hardware/GeoSlam/ZEB_Revo_and_Revo_RT/ZEB_Cam_for_Revo_-_GitUp_G3_Camera_Reset
Updated: Wed, 11 Oct 2023 20:02:38 GMT
3

12. Make the following video settings (note – the camera settings in step 9 must be made before making the video
settings):
Set up the video settings
Video Settings Page Changes to Default
Resolution 1 1440P4:3
Loop 1 OFF
Microphone 4 OFF
Stamp 4 OFF
13. Swipe down to exit the Video Settings page.
14. Power off the camera by long pressing the Power/Mode button.
15. Install the SD card in the camera.
16. Test the camera:
a. Power on the camera by long pressing the Power/Mode button.
b. After powering on the camera should automatically start to record.
c. Stop the recoding the long pressing the Power/Mode button. The camera should turn off.
17. Refit the camera in the frame and refit the camera retaining screw with a 4mm hex key.
https://knowledge.faro.com/Hardware/GeoSlam/ZEB_Revo_and_Revo_RT/ZEB_Cam_for_Revo_-_GitUp_G3_Camera_Reset
Updated: Wed, 11 Oct 2023 20:02:38 GMT
4