Global Sat TW-100 User manual

TW-100
Wearable Watch Tracker
Quick Start Guide

- 1 -
Introduction
1. Power/Reject /Back
2. Micro USB Port
3. Microphone
4. Notification /Answer/Confirm /Menu
5. Speed Dial#1/Up/Clock Switch
6. LCD
7. Speed Dial#2/Down/Clock Switch
8. Speaker
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
5.
6.
7.
8.

- 2 -
Charge TW-100
If you are using the TW-100 for the first time,
charge the TW-100 up to 3 hours.(The
included battery is manufacturer-approved
for use with the TW-100. The use of
any other battery might damage TW-100.)
Power TW-100 On/Off
Power On:
Press and hold the “Power”key for 5 seconds.
The LCD and backlight will turn on.
Power Off:
Press and hold the Power key until the display’s
power off bar fully finishes. Then the LCD and
backlight will turn off.

- 3 -
Install the SIM Card
1. Please make sure
TW-100 is power off.
Unlock 4 screws with the
proper screwdriver.
2. Remove the rear cover.
3. Remove the battery
carefully and then push
the SIM card cover
downward (opened).
4. Open the SIM card
cover.
5. Carefully make sure the SIM
card is installed correctly, with
the contact (gold part) of the
SIM card facing downward.
Close SIM card cover and
push it upward (locked).
6. Put the battery on the
original place.
7. Put the rear cover and
then Lock 4 screws
accordingly.

- 4 -
Notification Button
Press and hold notification button for 3 seconds to
send a message to the preset phone number and
then make a phone call to this number to deal
with the urgent matter.
Make Phone Call
You could make phone calls by long pressing the
speed dial 1 & 2 keys (button C & D).
You could answer the phone call by pressing
button B You could reject the phone call by
pressing button A.
A
B
C
D
A
B
C
D