Goldmedal 1661 User manual

Page 1 of 2
10700 Medallion Drive, Cincinnati, Ohio 45241-4807, USA 1-800-543-0862 gmpopcorn.com
© 2020 Gold Medal Products Co.
Part No. 110276
Gallon Wall Mount
Model No: 1661
The Gallon Wall Mount is intended for use with
a one gallon jug with dispensing pump. Securely
mount unit to wall for stability, see instructions below.
Follow the product manufacturer’s instructions
for product handling and use.
Items Needed (not included with unit)
•Philips Head Screwdriver
•Drill (use a bit smaller than the screw size to
make pilot holes for the lag screws)
•(2) 1/4” x 3” Hex Head Lag Screws and Washers
Items Included
•Gallon Wall Mount Bracket (PN 116590)
•(1) 14” Stainless Lanyard (PN 114690)
•(1) 8-32 X 1/4” Screw (PN 74142)
Mounting Instructions
1. Locate the center of a wall stud suitable for
mounting the unit.
Tip: Measure desired height for consistency
when mounting multiple units.
2. Hold unit in place (along wall stud center)
and mark the holes needed for the lag
screws—make sure unit sits level.
Note: Bracket has optional mounting
holes on left and right of center
for mounting flexibility.
3. Drill a pilot hole for each lag screw.
Gallon jug with pump shown for reference
only (not included with unit).
Find center location
of wall
stud.
Mark the 2 mounting
holes needed
.

Gallon Wall Mount Model No: 1661
Page 2 of 2
gmpopcorn.com
Care and Cleaning
Remove jug and wipe unit surfaces clean with a soft cloth slightly dampened with soap and water,
then wipe again with water only. DO NOT use abrasive materials as they will damage the unit.
4. Mount unit to wall using the 2 lag screws
and washers.
5. Insert a gallon jug with pump into the
bracket for use.
6. As needed, loop lanyard around jug and
fasten to unit with the 1/4” screw provided.
Align holes and fasten with
lag screws and washers
.
Lanyard can be fastened on
either side of unit.
Loop lanyard around jug.