Vonyx MS20 Microphone Stand HQ 2 section User manual

MS20 Microphone Stand HQ 2 section
Ref. nr.: 180.025
INSTRUCTION MANUAL
V1.0

INSTRUCTIONS
1. Upon receiving the stand, it will be presented in its most compact form. Turn the knob (as shown in above instructive
graphic) in counter-clockwise direction to loosen its grip on the main tube allowing it to slide out, increasing the length
of the stand. Turn the knob clockwise to tighten.
2. Fold out the legs until they are fully extended. No tightening of knobs or screws is necessary.
3. Turn the centre clutch counter-clockwise allowing you to extend the length of the stand. Turn clockwise to tighten.
4. Adjust the angle between main- and top tube by using designated knob. Again: turn counter-clockwise to loosen its
grip, turn clockwise to tighten again.
5. Adjust the length of the top tube by loosening designated knob (counter-clockwise rotation). Once adjusted, rotate the
knob clockwise to tighten.
TECHNICAL SPECIFICATION
Material: Metal
Dimensions boom: 90cm
Dimensions folded: 990 x 90 x 85mm
Dimensions min height: 95cm
Dimensions max height: 165cm
Weight (kg): 1.90kg
The specifications are typical. The actual values can slightly change from one unit to the other. Specifications can be changed
without prior notice.
Specifications and design are subject to change without prior notice..
www.tronios.com
Copyright © 2019 by TRONIOS the Netherlands