OPERATION:
• Comb through facial hair using the supplied Hair Comb to seperate hairs.
• If using the Adjustable Trimmer Guide, adjust to select desired hair length setting.
• Turn on the Trimmer.
• Place the flat base of the Trimmer / Adjustable Guide against the skin.
• Slowly slide the Trimmer Guide and Blades through hair. Repeat from different directions
as necessary.
• If hair builds up around the blades during the trimming process, switch the unit off, pull off the
Trimmer Guide and brush away hair using the supplied Cleaning Brush.
• Regularly check the level of collected hair in the vacuum chamber.
Once this becomes full, switch off the beard trimmer and empty vacuum chamber.
NOTE: For even cutting, allow the comb attachment/blade to cut its way through the beard hair.
Do not force it through quickly. If you are cutting for the first time, start with the the highest
position using the Adjustable Trimmer Guide.
CLEANING:
Always ensure the trimmer is unplugged and switched off before
cleaning. It is advised cleaning is performed over a waste receptical to
prevent loose hairs being scattered.
• Remove the Adjustable Trimmer Guide. Using the supplied Cleaning
Brush, brush loose hair from the Stainless Steel Clipper Blades.
• Open the Vacuum Chamber Cover and tip contents into
a waste recepticle.
• Use the Cleaning Brush to sweep out any remaining hairs.
• Brush away loose hairs from the Vacuum Filter inside the
Vacuum Chamber.
WARNING: DO NOT SUBMERGE ANY PART OF THE TRIMMER IN LIQUID.
TO ATTACH AND REMOVE ADJUSTABLE TRIMMER GUIDE:
The Adjustable Trimmer Guide is already attached the the Trimmer. To
seperate them, press the guide’s release button and pull the Trimmer Guide
away from the main unit.
To reattach, align the Adjustable Trimmer Guide with the Trimmer and slide
it into place.
(NOTE:When reattaching, a clicking sound means the trimmer guide
attachment is secure and ready for use).
ADJUSTABLE TRIMMER GUIDE:
NOTE: The Adjustable Trimmer Guide has various length settings.When first becoming familiar with
the Vacuum Beard Trimmer, begin with a higher numbered setting.
Adjust cutting length as desired by pressing the button on the
Trimmer Guide and sliding it up or down (0.5mm being shortest hair
length, 18mm the longest).
The number indicated on the side of the trimmer is the length of
hair that will remain.
Support Line: 0303 031 0888
For more innovative products from Good Ideas please visit:
www.shopgoodideas.com
